The stator on an Evinrude outboard is located under the engine flywheel.
It is a 1990 15 horse manual start evinrude.
To replace the stator on a 50 hp Evinrude outboard motor, first disconnect the battery and remove the engine cover for access. Then, locate the stator, which is typically mounted on the flywheel side of the powerhead. Remove the flywheel by loosening the flywheel nut and using a puller if necessary, then unscrew the stator mounting bolts and disconnect the wiring harness. Install the new stator by reversing these steps, ensuring all connections are secure before reassembling the engine cover and reconnecting the battery.
1990 evinrude 60 hp weight is 250 lbs
about 300 lbs
The 1990 model, 150 hp Evinrude outboard has a listed dry weight of 365 - 393 lbs, depending on the particular model.
The 1990 model, 90 hp Evinrude outboard can use either an NGK BR7HS, or Champion L77JC4.
The Evinrude 15 HP motor with the model number E15RLESR and serial number RO8539888 was manufactured in 1990. Evinrude's model numbers typically include the year of manufacture, and the "R" in the model designation indicates it is a 1990 model. Always check with a reliable source or Evinrude's official documentation for confirmation.
1990
50:1 mix
For the 1990 model, 25 hp Evinrude outboard, use a 50:1 ratio, roughly 1 pint of 2 cycle oil, to six gallons of fuel.
A for Alternator, S for Stator, I for ignition.
This is a 1990 120Hp motor with Electric start, Tilt & Trim.