in twin crew system probeller blade of port and stb is same or no?
In opposite direction, but they are designed to propel the boat forward even if they rotate in opposite directions.
Both the props in a Cessna 310 turn the same way--so the plane's got a critical engine.
You turn the screw in to idol down
Picture a nut on a screw. You are holding the nut so it can't turn, but allow it to go up and down the screw. The screw is restrained so it can turn, but not move back and forth. As you turn the screw one way and the other, the nut will move up and down the screw. That is a trivial example of one very common screw thread mechanism.
The best way to tighten a loose shower handle screw is to use a screwdriver to turn the screw clockwise until it is securely fastened.
if you know where the carb is then there will be a screw on it. first start your four wheeler then slowly turn the screw till the idol changes if it idols down then turn the screw the other way until it is at the idol speed you want.
You turn it counter clockwise to loosen.
Turn the fuel screw all the way in, the turn it out two and a half turns. Turn the pilot air screw half a turn in to enrich the fuel mixture and keep it from stalling at low speeds if needed. If the fuel mixture is too lean then turn the fuel screw out a little, like a half turn.
It depends if you are loosening it or tightening it.
bury screw all the way in and turn out 1.5 to 2.5 turns out
There is no way you cam change props in Prop Hunt TF2.
Its always counterclockwise. isn't it?