answersLogoWhite

0

It would depend on the alarm, a steady alarm indicates an engine over heat. If the engine alarm is a series of beeps, this would indicate an oil pump / supply failure.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why does my mercury outboard sound a three beep alarm and shuts down?

A three-beep alarm on a Mercury outboard typically indicates a warning related to engine overheating or low oil pressure. This safety feature is designed to protect the engine from damage. The outboard may shut down automatically to prevent further issues, so it's important to check the engine's cooling system and oil levels. If the problem persists, consulting the owner's manual or a qualified technician is advisable.


What activates the alarm on a 1994 Mercury 60hp outboard?

The warning system on the 1994 model Mercury outboard can be activated by either the low oil sensor, located in the bottom of the oil reservoir, or the overheat sensor, located in the block near the spark plugs. The oil sensor will cause a series of "beeps" while the overheat will sound a continuous tone.


How to change mercury outboard water pump?

You will probably have to drop the lower end of the outboard. Its sound hard but really it is usually quite simple. The pump is nothing more than rubber impeller on a brass collet.


What energy transformation does alarm clock have?

An alarm clock transforms electrical energy into mechanical energy to activate the ringing mechanism. Typically, the electrical energy powers a motor that sets the clock hands and triggers the alarm sound at the designated time.


When was Alarm Will Sound created?

Alarm Will Sound was created in 2001.


What is that beeping sound like an alarm clock when you start up a 1992 Mercury Sable Wagon that goes off about every 15 minutes?

You have to take it to a shop to have the computer resetAnswerMost likely it's either the door ajar alarm or the seatbelt alarm.


Makr a list of all the sounds that warn you of danger?

Fire alarm sound,anbulance siren sound,alarm bell sound and car theft alarm.


Why does the motor beep on a 115 horsepower efi mercury when you are goin along ease back on the throdle and it stops?

The beeping sound on a 115 horsepower EFI Mercury motor typically indicates an alarm related to engine performance or safety. When you ease back on the throttle and the engine stops, it could suggest an issue such as overheating, low oil pressure, or a fuel supply problem. The alarm is designed to alert the operator to a potential malfunction, prompting immediate attention to prevent further damage to the engine. It's advisable to check the owner's manual or consult a technician for specific troubleshooting.


What causes the alarm to sound continuously on a 1997 Mercury Mountaineer?

voltage drops on a weak battery can cause the alarm to trip. Whenever power is interrupted, even for a short time, the alarm will trigger. Sometimes not right away, but usually after the first drive after the power failure.


When was Sound the Alarm - The Dawn album - created?

Sound the Alarm - The Dawn album - was created in 2009.


What alarm clocks on the market make the bleep sound?

There are many alarms clocks that make a 'bleep' sound when the alarm is activated. One such alarm clock is the Casio Compact Battery LED Beep Sound Alarm Clock.


Why does an alarm sound on a 50 HP 1995 Mercury Outboard?

because your impellar is not pumping enough water to the engine to cool down so it's getting to hot, you probably need to change the impeller, even if water comes out it still could be worn mine was pumping water ok but when i took it off to check there was only one flipper left on it.