There are about 1030 BTUs in a cubic foot of natural gas. If one wishes to know the gas consumption (in feet3 per hour) for a given BTU per hour usage rate, one would divide the amount of BTUs by 1030. That would yield the number of cubic feet of gas that is used per hour. Q: I'm heating a space using 10,300 BTUs per hour and I'm using my natural gas heater to do it. How many cubic feet of gas am I using per hour? A: 10,300 BTUs (the heat generated per hour) divided by 1030 (the number of BTUs per cubic foot of gas) equals 10 cubic feet. You're using 10 cubic feet per hour. You apply 10,300 BTUs to heat the space per hour, and you use 10 cubic feet of gas per hour to do that. (And yes, I picked easy numbers.)
30 moles
Charcoal and gas grills usually cost around the same in the long run. It is more expensive to buy a gas grill, but charcoal to use in a charcoal grill is much more expensive than gas to use in a gas grill.
To find a calculator for how much gas you need for a trip, you can use http://fuelcostcalculator.aaa.com/. This gas calculator uses your vehicle details and trip distance to calculate how much fuel you would need .
it is extremely safe.
To run 400,000 BTU over a distance of 100 feet, you typically need a 2-inch gas pipe. This size accommodates the required gas flow while minimizing pressure drop. However, it's essential to check local codes and regulations, as they may have specific requirements or recommendations. Additionally, factors such as the type of gas and elevation can affect the final pipe size.
The size of the gas pipe needed for a propane stove typically depends on the distance from the propane tank to the stove and the BTU (British Thermal Units) rating of the stove. It is recommended to consult a licensed plumber or gas fitter to ensure the correct size pipe is used for the specific setup to ensure proper gas flow and safety.
only if the new pipe is bigger in which case all pipe leading up too it must also be of sufficient BTU rating. So.... No. You'll most likely have to get a new gas line run to your house or a lot of meter work done. maybe meter would have to be replaced to allow height total btu capability.
They come in different sizes.
To calculate whether a half-inch gas line can support both the water heater and gas cooktop, you'll need to consider the total BTU load of both appliances. In this case, a 50,000 BTU cooktop and the BTU rating of the water heater. You may need to consult a professional to ensure the gas line can provide the necessary gas flow for both appliances while maintaining safe operating conditions.
That would depend on the local codes and the BTU input of the appliance and the developed lenght of piping
btu of natural gas to btu of propane
Need more info to give correct pipe size. Gas company, plumber/pipefitter, or HVAC contractor should be able to assist with sizing.
Natural gas has a heating value of about 1,000 BTU/ft3 (gross) or about 900 BTU/ft3 (net). Acttual values can range about 100 BTU/ft3 higher or lower than the average. So 1,750x106 BTU would be about 2,000 ft3
The volume of gas would be 598.7 cubic feet.
The average is about 20,000 BTU's per pound at standard temperature and pressure.
Specifically 1013.2 btu per standard cubic foot, for pure methane.