Negative.
No, developed film should not be exposed to light as it can cause damage to the images on the film.
When exposed film is developed, it appears as a series of visible images on the film, showing the captured scenes in detail and clarity.
There are a few disadvantages to film cameras. The film must be loaded correctly, exposed correctly, removed from the camera & developed. There is a some latitude in the process of exposing your film but unless you process & print your own film you are at the mercy of the film tech (or computer.)
A movie film print is when they take the undeveloped film and send it off to be processed. What they get back is the fully developed film called the Film Print. It's the first time they get to see everything that was shot to make the movie.
When film is exposed to light, the chemicals on the film react to the light and create an image. This process is called photochemical reaction. The image is then developed and fixed onto the film, creating a photograph.
One reason film may come out blank is if it was exposed to light before it was developed.
When undeveloped film is exposed to light, it can become overexposed, resulting in a ruined or unusable image. This is because the light can prematurely expose the film before it is properly developed, leading to a loss of detail and clarity in the final photograph.
One way to tell if 35mm film has been used is to check for exposed frames on the film strip. If there are images or markings on the film, it has likely been used. Additionally, the film may appear slightly wrinkled or have slight scratches if it has been previously exposed and developed.
Exposed - film - was created in 2003.
The purpose of the rewind knob on a Canon camera is to manually rewind the film back into the film canister after it has been exposed and developed.
Short Answer: You will get a clear piece of film. You will also ruin your film developer and will not be able to use that chemical again.About FixerFixing the film is a permanent process, once a film is fixed, it remains the same even if you have to pass it through the developer thereafter.This is what happensFixer removes all of the light-sensitive emulsion on the film that was not exposed to light and then developed. So you will end up with a clear piece of film because nothing was developed first.Film that is exposed to light only creates a latent image. That image will not appear until it has been developed in a chemical bath, which "hardens" the image. The function of fixer is to remove all parts of the emulaion that have not been developed (hardened). Areas not developed become clear film. If you fixed the film first, you will remove all of the emulsion and there will be nothing left to develop.You will also ruin the developer chemicals if you first use fixer and follow it up with a developer in the process. These chemicals will have to be trashed and not used again. This is a shame, because when used properly, both film developer and fixer can be re-used several times.
The digital computer camera does not require film to take pictures. Once a picture is taken, it can be downloaded onto a computer to view and print whereas a film camera would need to have their film developed.