First you must pressure wash as best as possible. Next you need to acid wash the concrete. Finally you should be able to neutralize the acid with a vinegar and water solution. Let dry. You should prepare the whole floor this way.
.00046 (or 0.046%) per 1deg F over 20deg F
Coal Power plants are cheaper to build.
It wasn't actually invented more like discovered. It progressed over time. People were involved to get to the place it's in today. Not really any one person has invented petrol. It was a development over time. Petrol is commonly known as gasoline so: Who invented gasoline? No one.
The most common odor problem from a window ac unit is that there is a buildup over time in the drip pan. The pan collects condensation and allows it to drain through a hole in the ac unit. Over time the pan will collect dirt and other particles, and can develop mold. With the ac unit unplugged the cover will need to be removed, and the pan scraped out and washed.
afbc has high turn down ratio,burner arrangement is simple,low grade coal can be burnt efficiently,so2 emission can be controlled,
No, there is nothing for the Epoxy to bond to. The latex is creating a "bond breaker." You will need to use a water based or water born sealer with at least 20% solid acrylic. DO NOT USE solvent based sealers over latex. It will wrinkle the latex.
You can use powdered dish detergent. Pour on stain and let it soak, then use a broom and brush it over the concrete.
Usually when you're planning on going over it with additional concrete or cement, or in preparation for an epoxy or waterproofing coating.
Thee is no necessity to do that. Any 2 part epoxy is tough enough to withstand anything.
Either concrete stain or block and stucco paint. I painted an eagle statue ,about three year's ago with oil colors and after it dried i put a coat of polycrylic, (by Min Wax) over it and and it still looks great.
You should apply at least two coats of clear finish over a stain. Be sure to put thin coats of the clear finish on, you do not want it to be too thick.
Start by scraping off everything you can with a spatula or similar tool. The stain and residue on the concrete may be permanent, but you could try concrete cleaners designed to get oil stains out.
Yes, you can on some one-part epoxies; however, be sure to check the data sheet for the epoxy. Most solvent based epoxies will act as a remover when placed over polyurethane.
The Sharpie will eventually wash off the epoxy. The only way to keep any drawn image on it is to sand it down and do it or possibly draw with your Sharpie and apply a couple coats of epoxy clear coat over it.
If your old epoxy is good then you can apply over it, but there are many facts to consider before applying over existing epoxy coating.
Yes, it can.
You can definitely use latex paint over epoxy. In fact, it is recommended to use latex over epoxy by the paint manufacturers, rather than using epoxy over epoxy. The latex adheres better and if you then want to use epoxy next time you paint, you have a nice coat of latex between the layers. If you use epoxy over epoxy, often the paint will just peel off in layers once some time passes (and sometimes right away).