A wavelength of 11 meters puts you in the citizen's band. Most equipment uses vertical antennas, and so should you to have the best reception on both ends of a call. There are many ways to assemble a dipole, from a straight wire, to a ladder line, to a coaxial bazooka, to . . . . And many ways to connect your feedline to the radio transceiver: with or without a balun, with or without a balanced feedline, and so forth.
Try Googling for dipole antennas, and see what you come up with.
An atom is about 10-11 meter in diameter, so to make a chain of them 10-6 meter long you would need about 10-6/10-11 =105 or 100,000 atoms.
The dipole moment of 1,1-dibromoethene would depend on the orientation of the bromine atoms relative to the double bond. If the bromine atoms are on opposite sides of the double bond (trans configuration), the dipole moment would be zero. If the bromine atoms are on the same side of the double bond (cis configuration), the molecule would have a non-zero dipole moment.
Barium sulfate (BaSO4) is insoluble in water because the forces holding the Ba2+ and SO4 2- ions together in the lattice structure of the crystal are much stronger than the forces that water molecules can exert on them to break them apart. As a result, BaSO4 does not dissociate into its ions in water, leading to its insolubility.
To find out how many ounces of chemical it would take to make 100 gallons of finished dilution at 0.5%, we can set up a proportion. Since 11 ounces of chemical are used in 10 gallons of water, we can establish the ratio of ounces of chemical to gallons of water as 11:10. By setting up a proportion and solving for x, we find that it would take 110 ounces of chemical to make 100 gallons of finished dilution at 0.5%.
the number of protons is the atomic number, which for sodium is 11. The number of electrons in neutral sodium atom is 11 and these are in the following shells:- 1st valence = 2 electron 2nd valence = 8 electrons 3th valence = 1 electrons
To make an 11-meter 1-2 wave dipole antenna, cut two equal lengths of wire, each measuring approximately 5.5 meters (18 feet), which corresponds to half the wavelength at 27 MHz, the frequency used in the 11-meter band. Attach these wires to a center insulator, ensuring they are spread apart to form a "V" or horizontal shape. Connect the feedline to the center of the dipole, ensuring proper impedance matching for optimal performance. Finally, securely mount the antenna as high as possible for better signal propagation.
The half-wave, center-fed 'dipole' antenna is probably the antenna that's simplest to design, and easiest to build and operate. For 100 MHz, it's a single wire, supported at its ends and insulated from the supports, hung horizontally, opened and connected to a 75-ohm coaxial cable at its center, with an overall length of 4 feet 11 inches (1.5 meters).
10.56 but it's better to make it 11
Aqua Teen Hunger Force - 2000 Antenna 4-11 was released on: USA: 10 December 2006
An atom is about 10-11 meter in diameter, so to make a chain of them 10-6 meter long you would need about 10-6/10-11 =105 or 100,000 atoms.
The dipole moment of 1,1-dibromoethene would depend on the orientation of the bromine atoms relative to the double bond. If the bromine atoms are on opposite sides of the double bond (trans configuration), the dipole moment would be zero. If the bromine atoms are on the same side of the double bond (cis configuration), the molecule would have a non-zero dipole moment.
The question is wrong. feet in length unit square meter is an area unit. The question should be : What is 11 feet in meters? answer 3.3528 meters or What is 11 square feet in square meter? answer 1.0219 square meter
About 34.56m
Approximately 29,640 US gallons or 24,680 Imperial gallons.
To calculate the fall (or rise) for an 11-degree roof over 1 meter, you can use the tangent of the angle. The fall can be calculated as: fall = 1 meter * tan(11 degrees). This gives approximately 0.193 meters, or 19.3 centimeters of fall over 1 meter of horizontal distance.
The USA Volleyball rulebook states that the official measurements are 3/8" in diameter and 5'11" tall. The USA Volleyball rulebook specifies that the antennae should measure 5 feet and 11 inches tall and 3/8 of an inch in diameter. Read more: http://www.livestrong.com/article/145934-volleyball-antenna-rules/#ixzz2CpuxdfwL The USA Volleyball rulebook specifies that the antennae should measure 5 feet and 11 inches tall and 3/8 of an inch in diameter. Read more: http://www.livestrong.com/article/145934-volleyball-antenna-rules/#ixzz2CpuxdfwL
11,000 mm 1 meter = 1000 millimeters 1 millimeter = 0.001 meter