Use a magnet to remove the iron filings. Filter the remainder to separate the insoluble chalk powder from the water. Wash and dry the iron filings as they will be contaminated. Dry the chalk powder to remove traces of water.
Use a magnet to remove the iron filings from the mixture, then mix the remaining components with water. The copper sulfate will dissolve but the CaCO3 (chalk powder) will not. Filter the mixture to remove the chalk, then boil the water to recover the copper sulfate.
One way to separate iron powder and sulfur powder is by using a magnet. Since iron is magnetic, you can attract and separate the iron powder from the sulfur powder. Another method is to use a technique called sublimation, where the sulfur powder is heated to convert it into a gas, leaving behind the iron powder.
yes it is hard though
You can use a magnet to separate the iron fillings from the sulfur powder. The iron fillings will be attracted to the magnet, allowing you to easily separate them from the sulfur powder.
One method is to use a magnet to separate the iron fillings from the sulfur powder, as iron is magnetic but sulfur is not. Another method is to mix the mixture with a solvent that dissolves the sulfur powder, leaving the iron fillings behind. Lastly, heating the mixture can also cause the sulfur to sublimate, leaving the iron fillings behind.
Use a magnet to remove the iron filings from the mixture, then mix the remaining components with water. The copper sulfate will dissolve but the CaCO3 (chalk powder) will not. Filter the mixture to remove the chalk, then boil the water to recover the copper sulfate.
Use a magnet to remove the iron filings... Warm (do not boil) the remaining mixture to evaporate the naphthalene.
you dont.
Magnet
First remove iron filings with a magnet. That leaves sand, salt and chalk dust. Add water which dissolves the salt, and filter leaving the sand and chalk dust on the filter paper. Put that back in water and add acid to dissolve the chalk dust (CaCO3) leaving the sand as a solid. Filter to obtain the sand. The chalk dust will now be in the acid as CO2 and H2O and the Ca salt of the acid.
One way to separate iron powder and sulfur powder is by using a magnet. Since iron is magnetic, you can attract and separate the iron powder from the sulfur powder. Another method is to use a technique called sublimation, where the sulfur powder is heated to convert it into a gas, leaving behind the iron powder.
A magnet will attract the iron leaving the coffee behind. It is also possible to separate them by flotation on water; add some detergent to the water to break the surface tension so the iron powder can sink while the coffee powder floats.
iron starts melting
a very simple and a common technique to separate them out is use a magnet. Since a magnet attracts iron , bring a strong magnet in front of the mixture and almost all of the iron powder gets separated
yes it is hard though
You can use a magnet to separate the iron fillings from the sulfur powder. The iron fillings will be attracted to the magnet, allowing you to easily separate them from the sulfur powder.
a magnet would pull out the iron, and leave the salt.