answersLogoWhite

0

The hole at the bottom will spurt the most water since the pressure is higher at the bottom compared to the top.

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Chemistry

What is filled with holes but still holds water?

A sponge.


How do you make an improvised separatory funnel?

Assuming you are in a lab with access to glassware, any container can be used as a sep funnel, really. When separating the layers, you must carefully decant the top layer (very difficult) or use a pipette to pipette out the bottom layer (very time consuming but possible).


Why does mercury have holes?

Mercury has holes in it because of the impact of larger meteorites hitting into it. These holes are commonly scientifically referred to as impact craters.


What has holes but hold water?

a sponge


How do you make a perculator bong?

Materials needed:-3 bottles all the same type-3-4 bendy straws, its up to you how many-Knife-electrical tape/Hot glue gun(looks nicer, and holds better)1)Take 2 of the bottles and cut their ends off2) Take a cap from one of the bottles and make 3-4 holes in it (depends on the # of straws your using)3) Put your straws in these holes (bendy side sticking up through the top of the cap) and attach them with your tape/glue to the cap4) Trip off the excess from the bottom of the cap5) Attach cap to one of the bottles without a bottle6) Take this bottle with the caps and glue/tape it to the bottle with a bottom (make sure you take the cap off of the bottle with a bottom ;)7)take the other bottle without a bottom and place it on top of the one with the bendy straws8) cut out a hole in the side of the bottom bottle for your sliderAND Wa-la*Fun Extra Steps!!! (require blunt tube and a spice container)9) Take blunt tube and cut it so it will fit into the bottom bottle (HORIZONTALLY)(optional-Cut slits in the blunt tube to mimic a diffuser, which allows for bigger hits)10) Before attaching it to the bottle, cut a hole in the side of the spice container and attach the blunt tube.11) Cut hole in the top of the spice container for your slider12)slide ur blunt tube attached to the spice container all the way into the bottom bottle with just a little bit of the blunt sticking out and tape/glue itThis makes it extra awesome ;) enjoy

Related Questions

What can a pitcher be filled with so its lighter than when it is filled with air?

Holes.


Are there any holes in the dirt around your house that need to be filled or repaired?

Check for any holes in the ground near your home that may need to be filled or repaired.


How can I install a water bottle cage on a bike without holes?

You can install a water bottle cage on a bike without holes by using adjustable clamps or straps designed for this purpose. These clamps or straps can be attached to the bike frame securely, allowing you to mount the water bottle cage without drilling holes.


How are electron holes in the molecules filled?

first, the electron holes are filled with electron guillotine called flumenya, then the air absorbs the flumenya creating a hard substance called tiddita


How do you clean sunroof drain holes ford escape?

A bottle brush is perfect for cleaning sunroof drain holes on the Ford Escape. The smaller tip on a two-tip bottle brush can be inserted and then pulled out to clean sunroof drain holes.


What is filled with holes but still holds water?

A sponge.


What was formed from lava that was cooled with hot gases trapped inside causing it to be filled with air holes?

The rock will have little holes.


What will you observe when four holes are drilled in bottle filled with water at same height?

The water will start to spurt out from each hole due to the increase in pressure caused by the weight of the water above it. The water streams will resemble a fountain-like effect.


What can a pitcher be filled with so it is lighter than when it is full of air?

Holes.


Is it true that earthworms only come to the surface when their holes are filled with water?

No


How are caves being protected?

The hermits are being relocated and the holes filled in.


Can you get a vertical labret piercing in an existing labret pierced?

No. Vertical labrets don't touch the inside of your mouth at all. The holes wouldn't match up.