No - it is a solvent that will dissolve resins
Acetone will dissolve many epoxy resins and they will go into solution. There are a few available commercially. However, once the epoxy resin (oligomer) is polymerized or cross-linked by an amine for example, acetone will not dissolve it but only soften it.
Acetone is a strong solvent that can dissolve the ink in permanent markers. The ink in permanent markers is designed to be resistant to water and fading, but it is not resistant to the powerful solvent properties of acetone. When acetone is applied to a surface with permanent marker, it breaks down the ink and allows it to be wiped away.
No, because when you add acetone to acetone, all you are doing is adding more of the volume of acetone to acetone. You are just changing the amount of acetone, not anything chemically happening.
Acetone molecules evaporate when you add heat to a beaker of liquid acetone.
Acetone is not known as hygroscopic.
No, acetone is not a hardener for resin
acetone
Acetone will work fairly well to remove the polyester resin--until the resin sets. Trichloroethane (e.g., ZipStrip) will soften the cured resin, possibly enough to remove it. Always try it on an inconspicuous spot before you commit to treat the whole garment. I know of a guy who had to wear a towel home because the acetone turned his polyester trousers into what looked like snot when he soaked them.
Acetone will dissolve many epoxy resins and they will go into solution. There are a few available commercially. However, once the epoxy resin (oligomer) is polymerized or cross-linked by an amine for example, acetone will not dissolve it but only soften it.
Probably not. Nail polish is normally acetone based and that doesn't blend with the resin used in oil based paints.
If the fiberglass has not yet cured then it can me removed using acetone. Acetone is often the main ingredient in nail polish remover. Be sure to test on a small area first since acetone can damage some fabrics. If the fiberglass has cured try soaking with Trichloroethane to soften the fiberglass enough to remove it. Again, it is important to test on a small area of the garment first to be sure that it does not damage or discolor the garment.
Acetone is a strong solvent that can dissolve the ink in permanent markers. The ink in permanent markers is designed to be resistant to water and fading, but it is not resistant to the powerful solvent properties of acetone. When acetone is applied to a surface with permanent marker, it breaks down the ink and allows it to be wiped away.
No, because when you add acetone to acetone, all you are doing is adding more of the volume of acetone to acetone. You are just changing the amount of acetone, not anything chemically happening.
Yes, mainly there are 3 types of acetone: regular acetone, acetone with enriched formula, maximum strength acetone.
Acetone has a lower boiling pt. than water because it has a higher vapor pressure. Liquids boil at the temperature where their vapor pressure is equal to the atmoshperic pressure. The temperature that acetone must get to, such that its v.p. is equal to the pressure of the atmosphere, is lower than what is required for water. Therefore, acetone has a lower B.P.
1.) Go to the store. 2.) Buy nail polish remover. 3.) Use as directed on the label.
With that same resin's liquid resin.