Never add water to an acid always add small amount of acid slowly in large amount of water.
To prepare dilute hydrochloric acid (HCl) from concentrated HCl, you can add the concentrated acid to a large volume of water in small increments while stirring. Always add acid to water and not the other way around to prevent splattering. Dilute the solution to the desired concentration by adjusting the ratio of acid to water. Remember to wear appropriate safety gear and work in a well-ventilated area.
To raise the pH of water from neutral (pH 7) to pH 9, you would need to add an acid in small amounts while monitoring the pH. It is recommended to use a pH meter or test strips to accurately measure the pH and slowly add the acid until reaching pH 9. The exact amount of acid needed would depend on the volume of water and the strength of the acid being used.
When mixing acid and water, always add the acid to the water slowly and carefully. Never add water to acid, as it can cause a dangerous reaction.
If you add acid to water, the water slowly turns into a dilute solution of acid. If you add water to acid, it creates a large amount of heat (exothermic reaction), which can be very dangerous.
To dilute an acid, you can slowly add the acid to water while stirring continuously. Always remember to add acid to water and not water to acid to prevent splattering. Aim for the desired concentration by adjusting the ratio of acid to water.
you add acid to water
When mixing acid and water, always add the acid to the water, and add it slowly. Never add the water to the acid.
To prepare dilute hydrochloric acid (HCl) from concentrated HCl, you can add the concentrated acid to a large volume of water in small increments while stirring. Always add acid to water and not the other way around to prevent splattering. Dilute the solution to the desired concentration by adjusting the ratio of acid to water. Remember to wear appropriate safety gear and work in a well-ventilated area.
A large amount of heat is released when strong acids are mixed with water. Adding more acid releases more heat. If you add water to acid, you form an extremely concentrated solution of acid initially. So much heat is released that the solution may boil very violently, splashing concentrated acid out of the container! If you add acid to water, the solution that forms is very dilute and the small amount of heat released is not enough to vaporize and spatter it.
To raise the pH of water from neutral (pH 7) to pH 9, you would need to add an acid in small amounts while monitoring the pH. It is recommended to use a pH meter or test strips to accurately measure the pH and slowly add the acid until reaching pH 9. The exact amount of acid needed would depend on the volume of water and the strength of the acid being used.
No, but you can add distilled water if it has filler caps and it is low of electrolite. Do not add tap water or acid.
When mixing acid and water, always add the acid to the water slowly and carefully. Never add water to acid, as it can cause a dangerous reaction.
If you add acid to water, the water slowly turns into a dilute solution of acid. If you add water to acid, it creates a large amount of heat (exothermic reaction), which can be very dangerous.
To dilute an acid, you can slowly add the acid to water while stirring continuously. Always remember to add acid to water and not water to acid to prevent splattering. Aim for the desired concentration by adjusting the ratio of acid to water.
if the acid is hygroscopic like concentrated sulphuric acid then always add acid into to water but not water into acid if u want to dilute the acid because the liquid bumps and may injure the worker....
Add specific amount of acid in calculated amount of water.(not water into acid).
To safely add acid to water, always remember to add acid to water slowly and stir continuously. This helps to prevent splashing and potential hazards, as adding water to acid can cause a violent reaction.