Chemicals such as aluminum sulfate or ferric chloride are used to coagulate particles in the water supply, which can sometimes lead to a slimy feel. Additionally, naturally occurring minerals like manganese or iron can also contribute to a slimy texture in water.
Put hand sanitizer in a bag then put some water in the bag it depends how much sanitizer you put in there and squish it up together if you want color to it then get a marker and get ink out of the marker but put color first (option)then put water
No, you cannot make slime with just water, flour, and glue. Slime typically requires a slime activator (such as borax, contact lens solution, or laundry detergent) to create the desired texture and consistency. Mixing water, flour, and glue will likely result in a sticky paste rather than slime.
Bath water can turn brownish purple if minerals, such as manganese and iron, are present in the water supply. These minerals can react with the chlorine in the water, causing discoloration. It could also be due to a build-up of dirt or rust in the pipes.
This could be caused by a faulty mixing valve in the water heater, which is allowing hot water to mix with the cold water supply. It could also be due to a crossover in the plumbing system, where hot and cold water lines are connected. Both of these issues can be diagnosed and repaired by a plumber.
The answer is a Black light and Tonic Water. Tonic water contains a chemical called quinine which makes it glow bright blue when the water is exposed to black light.You take a bowl and put water or Tonic water just in case you want to drink it.Then you put highlighter ink in the water then stir the ink in the water. It looks kinda weird, but then you put the black light over it and it GLOWS.
It's a mossy film that grows on them a fungus, look at the bottom of a pond sometime.
No Sedona, Arizona does not put fluoride in it's water supply. In the US over 70 percent of cities and towns put fluoride in the drinking water.
A put-put engine is extremely simple. It has a tank which contains water with two tubes leading from the water supply, perhaps in a pond. Under the tank is a source of heat which brings the water in the tank to the boil and makes steam. This steam rushes down the two pipes to the water supply, so moving the boat forward, almost like a jet engine. But that lasts only for a very short time because the steam condenses in the colder water, thus reducing the pressure in the tank such that a little more cold water enters the tank, which is heated to "steaming point" once more. So we hear the put put put put put........
no. water put on water makes more water. its the same as land on land. put land on land, makes more land not dyer land.
Put holy water on it
Put a band aid or any medic supply to it so it will stop bleeding
cause you put it in cold water... so it makes it cold.
The water supply was contaminated. The company contaminated the soil with their chemicals.
put water on it
Because water flows downwards, and by help of which we can get a evenly distributed water supply in the house.
You cut off its oxygen supply, no fuel-no fire
Greasy hair is when your hair is slimy and greasy from all the hair products you put in it.