This means a 95.5% tin alloy with 4.5% other metals. You will have to check the solder's specification sheet to determine the other metals and now much of each is present.
A Conductor, SOLDER IS NOT AN INSULATOR. The most common types of solder are made of tin and lead. Another type is silver solder. All of the materials used are metals and are good conductors of both heat and electricity. If you solder something you would notice if you ever held a wire (without protection) while applying solder to it your finger would probably receive a burn (speaking from experience).
Soder used to be made of a mixture of tin and lead. But when it was discovered that lead was poisonus, it changed to a mixture of mainly tin.
Cold solder joint: occurs when the joint doesn't fully melt, leading to poor electrical conductivity. Insufficient solder: not enough solder used, resulting in weak or incomplete bonds. Excessive solder: too much solder applied, causing bridging or short circuits. Solder balling: result of excess solder that forms into small balls. Solder splashes: occurs when excess solder splashes onto nearby components. Solder flux residue: leftover residue from flux can lead to corrosion or poor connections over time.
Solder is typically made from a combination of tin and lead, although lead-free options are also available. These metals are melted and used to join together other metal components.
Solder is a lead alloy with tin. Different mixes have different melting points, and for some work, silver is also added. Sometimes for electronic work, solder is presented in the form of a wire with several cores of rosin inside it. This was first made as a large billet of solder - the size of a pot - in which several holes were drilled and filled with rosin. The solder is then drawn out in a series of rollers in the same way that other wires are made from a billet of metal. The function of the rosin is to clean the surface of the metals to be joined, so the solder may easily adhere. For plumbing use, acid cores are used, but these should never be used in electronics. yo momma!:)
soft solder is made of tin and lead. :D
solder and iron
955
Solder has been used for thousands of years, with evidence of its use dating back to around 4000 BC. The modern form of solder that we use today, typically made of a combination of tin and lead, was developed in the 19th century.
A reel of solder used for joining electrical circuits together on circuit boards. Solder is made of a mixture of tin and lead and sometimes has has flux (a form of acid) in the core of the solder to ensure a clean surface for the solder to flow into.
Plastic, solder, and resistors.
Solder
Traditional electronics solder also contains resin.
106.1111
955 = 5 x 191
Its factors are: 1, 5, 191 and 955
well wetted round both conductors, and will appear shiny and smooth.