answersLogoWhite

0

The Proton Wira firing order is 1-2-3-4 for the four-cylinder VDO engine. This fuel injected engine came into use in 1991 and is slightly different than previous models, some of which included carburetors.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

When was Proton Wira created?

Proton Wira was created in 1993.


What is the Proton Wira cylinder head bolt torque specs?

50ft. lb


Has a forklift training video been filmed in Omaha, NE?

A forklift training video is filmed in omaha. It is a video of saving a proton wira with a forklift. But the fact is that proton wira is not worth of even the fuel cost of forklift


Who was the manufacturer of the car Proton Wira?

The Malaysian automotive company Proton released the Proton Wira in 1993 and continued to produce them until 2007. The car was made in two different styles, the first being a four-door saloon and the other being a four-door hatchback.


Where can you find the indicator flasher unit in a proton wira?

if indicator flasher is signal relay then its underneath dashboard, driver's side..


Where can you find the fuse box in a proton wira?

In a Proton Wira, the fuse box is typically located under the dashboard on the driver's side. It may be a rectangular or square-shaped box with a cover that can be easily removed to access the fuses. Refer to your owner's manual for the exact location of the fuse box in your vehicle.


When was Wira Gardiner born?

Wira Gardiner was born in 1945.


When was WIRA created?

WIRA was created on 1996-11-01.


When was Brad Wira born?

Brad Wira was born on 1972-03-16.


Where is the fuel sensor in proton wira?

most modern cars have the sensor or sender [as its commonly know] with the fuel pump in the tank..to get it them you need to find where there is an inspection cover [commonly under rear seats] undo it and withdraw the pump along with sensor and usually filter as well these days..


What was the firing order of Nissan diesel RE10?

firing order


Where is the obd2 port of 1999 proton wira?

Below the steering wheel. It will have 16-pin but not OBD2 compliant. You will need an adapter to convert the to OBD2. The engine (presumably) Mitsubishi 4G15 Efi which originally 12-pin. Proton did not use 12-pin but maintain the 16-pin where 4 pins are not used.