the size of the object. there are diffrent sizes of c clamps
A pinch clamp.
to clamp the screw
edi! iron ring and iron clamp....
What should you call a man with a clamp
It's used for clamping a buret, of course. I can actually think of three distinct pieces of equipment that could reasonably be called a "buret clamp", and I'm not certain which of them you mean. One of them is a pinch clamp used to clamp the outflow tube (a rubber or plastic tube from the bottom of certain types of burets). Another one is sometimes called a tube clamp, and is a piece of hardware used to secure a glass tube of some kind (such as a buret, but also a test tube or parts of a vacuum manifold) to a metal stand or framework. Finally, there's a specialized spring-loaded piece of hardware used specifically for burets, which holds and supports them in two places on the tube (the tube clamp clamps onto the buret in a single location on the tube).
a clamp in the shape of a c where you tighten it by twisting the end.
6"
A C-clamp is a clamp that is in the shape of a "C" that screws down to hold pieces together. A Bar-Clamp is a long clamp made from a bar or steel rod that has grips on each end that can be adjusted along the bar and engages ratchets and then can be screwed down to tighten. So a long clamp with C shape end clamps coule be called a C-bar clamp.
bench voice, voice grip, g clamp, c clamp, hand clamp, jumper cable. these are only hand tools
any kind of standard size compression or clamp
You can either use a c clamp or c clamp vise grips hope this helpa
you can use the c clamp just tighten it slowly
A C-clamp contains a screw, a lever, and a wheel and axle.
A C-clamp is a tool, essentially it is a C-shaped piece of metal with one flat surface and a threaded rod with a "foot" and handle on opposite ends. Turning the threaded rod in a clockwise direction closes the C and forms a clamp. See the link below for an image.
You dont compress a piston with a C clamp, you use a piston ring compressor to compress the rings and tap the top with a hammer to sit it back in to the cylinder bore. The C clamp is used for compressing valve springs. *AArOn*
any standard size clamp will fit razor bars
1 3/8 inch inner diameter clamp