0
What else can I help you with?
If you put water mercury mineral oil a cork a rubber stopper and lead in a graduated cylinder in what order would they be in from top to bottom?
From top to bottom, the order would be: cork, rubber stopper, mineral oil, water, mercury, and lead. This is based on the densities of the substances, with cork being the least dense and lead being the most dense.
if you put oil in water while water will be evaporated?
Unless the oil is very hot, no. Water evaporates as a result of heat transfer.
What happens when you mix water and fire with oil?
The oil and water would separate (oil is lighter than water, thus it would float upon the water) Therefore the oil could catch fire and burn until it was all burned without the water putting it out
How do you separate salt and oil?
HOW TO SEPARATE SALT FROM OIL .First of all to separate salt from oil you need to pour some water, salt, and oil into a beaker in that order. .After you have put those materials in the beaker, you should see the salt dissolving, then you should be left with oil and water. .Next to separate the oil from the water you could either, leave the solution for a while and the oil eventually should rise to the top and float above the water, or you could use a funnel with a stopcock at the bottom which will allow you to drain the water out underneath the oil. GOOD LUCK! :)
A plastic disks density is less than water but greater than oil if you put all three together in a glass container where would you see the plastic disk?
The plastic disk would float on top of the water but sink below the layer of oil in the glass container. This is because the density of the plastic disk is in between that of water and oil.
Does the order in which you add liquids affects the order of the layers formed by those liquids?
No, it doesn't matter. If you put water and oil in a cup, the oil will always be on top of the water, no matter the order that you put them in. This is because oil is less dense then water:)
If you put water mercury mineral oil a cork a rubber stopper and lead in a graduated cylinder in what order would they be in from top to bottom?
From top to bottom, the order would be: cork, rubber stopper, mineral oil, water, mercury, and lead. This is based on the densities of the substances, with cork being the least dense and lead being the most dense.
Blinking oil light 2002 mercury sable?
put some oil in it then!!
Pictures of where to put oil in mercury villager?
Engine oil goes in the oil cap which is right on the front of the engine and has a picture of an oil can on it.
How many quarts of oil go into a 1992 mercury grand marquis?
when i do my oil change i put 6
Why do not put water on an oil flame?
oil gets on top of water and oil is flamable
Where do you put motor oil in the engine of a 1993 Mercury Sable?
Ummm...in the engine?
What type of oil do you put in a 1996 mercury sable?
( 5W-30 ) is the preferred oil , according to the Owner Guide
How many quarts of motor oil do you put into your 1992 Mercury Tracer?
About 4 quarts.
What do you put an oil fire out with?
water?
What is the oil capacity in a 2005 mercury grand marquis?
6 quarts will put it right on the mark.
In which order did the Egyptians put stuff on oil then resin or resin then oil?
oil then resin!
