0
What else can I help you with?
Would fevers run higher or lower if liquid water's specific heat were not so high?
Fevers would run higher if liquid water's specific heat were lower. The amount of energy need to raise our body temperature would be less. Although the body would still develop control mechanisms to regulate the temperature to prevent heat death of the cells.
If all the SCN were not converted completely to FeNCS when the calibration curve was prepared would this raise or lower the value of Keq?
Sorry, since it is unknown of what experiment or laboratory analysis you're talking about, this question is unanswerable. It also is not accurate enough: FeNCS is not a good formula, SCN is an anion: SCN- and the sentence:".... when the calibration curve was prepared(??) would this raise or lower the value of Keq" is difficult to interprete as such a curve is not adequately described.
It is determined that a patient is in acidosis What does this mean and would you treat the condition with a chemical that would raise or lower the pH?
The patient has excessive acid in the body fluids. You would treat the patient with a chemical that would raise the pH (lower pH=more acidic, so you need to raise the pH because higher pH=more basic)
What effect would a decrease or increase in barometric pressure have on the boiling point?
If you were to travel to Denver, the mile high city, air pressure is reduced. This makes it easier for gas molecules to escape the liquid, hence the boiling point lowers. On the other hand, when pressure increases, gases have a harder time escaping the liquid so the boiling point must increase.
Can you siphon out of and back into the same container?
The basic principle of the syphon system is that the difference of pressure at both the ends of the tube would drive the liquid from the level of higher pressure to that of lower pressure. If, suppose, the level of liquid becomes the same in both the container then flow of liquid would stop. So, if you want to send back the liquid, then you have raise the container above the first one, then liquid would start flow from the second to the first.
What liquid would be the most difficult to raise and lower the temperature of?
One with a high heat capacity
How do you lower or raise a basketball net?
There are usually two ways to lower a basketball net. Either there will be a lever on the back, and you would scroll that around to raise or lower, or there is a lever, and you pull it down to raise the net and push it up to lower the net.
The opposite of lower?
If you're talking about "lower" as the comparative of the adjective low (low, lower, lowest) the opposite would be "higher". If however you mean the verb "to lower" an adequate opposite to use would be "to raise".
What do each of the 8 badges in Pokemon diamond do?
the allow you to have the power to raise your cholesterol level up when you want. why would you want to raise it you say? to lower it, of course! the allow you to have the power to raise your cholesterol level up when you want. why would you want to raise it you say? to lower it, of course!
Would fevers run higher or lower if liquid water's specific heat were not so high?
Fevers would run higher if liquid water's specific heat were lower. The amount of energy need to raise our body temperature would be less. Although the body would still develop control mechanisms to regulate the temperature to prevent heat death of the cells.
Which would raise pH more ammonia vinegar coffee or lemon juice?
Ammonia, which is basic, would raise pH. Vinegar, coffee and lemon juice are all acidic and would cause pH to be lower.
Why was it difficult to raise crops in sumer.?
It was difficult because the floods would wash away any young plants
If the supply of workers and demand for workers is at an equilbrium what would be true?
there is no pressure to raise or lower wages.
What would cause a transmission to not shift into gear and the speedometer to raise and lower?
Sounds like a grenaded transmission
If all the SCN were not converted completely to FeNCS when the calibration curve was prepared would this raise or lower the value of Keq?
Sorry, since it is unknown of what experiment or laboratory analysis you're talking about, this question is unanswerable. It also is not accurate enough: FeNCS is not a good formula, SCN is an anion: SCN- and the sentence:".... when the calibration curve was prepared(??) would this raise or lower the value of Keq" is difficult to interprete as such a curve is not adequately described.
Would float on liquid mercury whose density is 13.6?
Yes, an object with a lower density than liquid mercury (13.6 g/cm³) would float on it. This is because objects float when they displace an amount of liquid with a weight equal to or greater than their own weight. Since the density of the object is lower than that of the liquid mercury, it will float.
Effects in boiling point when sand is added to an organic liquid?
Sand is pretty inert, so it should have very little effect. However, if some of the sand does dissolve in the liquid, it would raise the boiling point of the liquid.
