because the hydrogen starts to burn and causes fire and it also spits out very hot acid which is dangerous for your eyes and could burn your skin instantly.
Potassium chloride is the answer as it would've neutralised the other liquid and the salt is potassium nitrate and therefore is named after like the salt and neutralisation put in.
To extract potassium from a banana, you would need to first dry the banana, then incinerate it to ash. The potassium would be present in the ash, which can be dissolved in water to create a potassium-rich solution. This solution can be further processed to isolate potassium compounds.
It reacts, probably explosively. The products are potassium chloride and hydrogen. The heat of the reaction and the fact that the hydrogen becomes mixed with atmospheric oxygen , makes it explode. to form water. Here are the reaction eq'ns/ 2K(s) + 2HCl(aq) = 2KCl(aq) + H2(g) 2H2(g) + O2(g) ==heat of reaction==> H2O(l) . NB Remember the general acid reactions. Acid + Alkali = Salt + Water Acid + Base = Salt + Water Acid + Metal = Salt + Hydrogen (as per this one above). Acid + Carbonate = Salt + Water + Carbon Dioxide.
Write the reaction when potassium sulfide is put into water:
When potassium metal is added to dilute hydrochloric acid, a chemical reaction occurs where hydrogen gas is produced and potassium chloride is formed. The reaction is represented by the following equation: 2K(s) + 2HCl(aq) → 2KCl(aq) + H2(g)
Potassium chloride is the answer as it would've neutralised the other liquid and the salt is potassium nitrate and therefore is named after like the salt and neutralisation put in.
It would depend on which acid and alkali were involved, the general rule is that adding an acid to an alkali will produce a salt and water. Sulphuric acid and sodium hydroxide would give sodium sulphate + water Hydrochloric acid and potassium carbonate would give potassium chloride and water and carbon dioxide etc
To extract potassium from a banana, you would need to first dry the banana, then incinerate it to ash. The potassium would be present in the ash, which can be dissolved in water to create a potassium-rich solution. This solution can be further processed to isolate potassium compounds.
You should never put on your high beams - it makes it much worse.
Flame test. Dip a piece of platinum wire into concentrated nitric acid, and then roll it in the sample. Put the wire over a Bunsen flame. If a lilac flame is observed, it is potassium nitrate.
It reacts, probably explosively. The products are potassium chloride and hydrogen. The heat of the reaction and the fact that the hydrogen becomes mixed with atmospheric oxygen , makes it explode. to form water. Here are the reaction eq'ns/ 2K(s) + 2HCl(aq) = 2KCl(aq) + H2(g) 2H2(g) + O2(g) ==heat of reaction==> H2O(l) . NB Remember the general acid reactions. Acid + Alkali = Salt + Water Acid + Base = Salt + Water Acid + Metal = Salt + Hydrogen (as per this one above). Acid + Carbonate = Salt + Water + Carbon Dioxide.
water
A toy.
An infant or car seat should never be put in a front passenger seat that has an air bag
Write the reaction when potassium sulfide is put into water:
It is possible that muriatic acid will damage the soil on a permanent basis. If your soil needs additional acid, vinegar works better than anything.
most diuretics are potassium depleters therefore most people need potassium ... most likely if you are getting put on a diuretic then your doctor will do a baseline lab to check potassium level and then after a week or more of diuretic therapy they will check your potassium level again to decide if you need potassium and they should monitor your potassium periodically also kidney function because some diuretics are hard on the kidneys hope this helps