The amount of cement required for wall tiling depends on the thickness of the adhesive layer used. Typically, for wall tiles, a thin-set mortar application might require around 2 to 3 kg of cement per square meter. However, this can vary based on the type of tile and surface conditions, so it's best to refer to the manufacturer's guidelines for specific recommendations.
How much cement required for grouting of block (16"x8"x8") wall for 100 sft area
Just the installation for a ceramic or porcelain tile will be around $3-$4 per sq ft for floor & $4-$5 for wall tiles. If you're talking marble, granite or slate it's gonna be in the $5-$6 per sq ft & $6-$7 for wall tiles.
32
You can, but you want to be sure the ceramic tile is not cracked or broken, make sure it is even, and not loose. It is reccomended that you you always remove any old tile before tiling. You can always lay a subfloor on top of the old tile to ensure your new tile was crack or pop out.
The number of bags of cement required for a 1 square meter concrete hollow block (CHB) wall depends on the thickness of the mortar joint and the size of the blocks used. Generally, for a standard 10 cm thick CHB wall, you would need approximately 0.03 to 0.05 cubic meters of mortar, which translates to about 1 to 1.5 bags of cement (assuming a 40 kg bag). Always consider specific project requirements and local practices for an accurate estimate.
The amount of cement required for wall tiles can vary depending on the tile size, thickness, and the adhesive method used. Generally, for 1 square foot of wall tile, you might need approximately 0.5 to 1 pound of thin-set mortar, which is a cement-based adhesive. This amount can fluctuate based on the specific tile and installation technique. Always refer to the manufacturer's guidelines for precise measurements.
The amount of cement required for wall tiling can vary based on factors like tile size, thickness, and the type of adhesive used. Generally, for 1 square foot of wall tile, you might need approximately 0.5 to 1 pound of cement if using a thin-set mortar. It's essential to follow the manufacturer's recommendations for the specific adhesive to ensure proper coverage and bond strength.
you have to remove paint n rough the surface then put some cement slurry n paste the tile by cement
Not JUST a grout no. You can get a cement that will also work as a grout but a pure grout would not have the adhesion required to stick the tiles to the wall properly, you should not use it as a cement.
How much cement required for grouting of block (16"x8"x8") wall for 100 sft area
at present condition 10*10 room how much bricks and cement and iron rod and blue stone Required
It is certainly possible to tile a floor, but bear in mind, there is much more pressure placed on the floor than on the walls, and floor tile must be laid over a solid cement base, otherwise it is going to crack.
The best adhesive for wall tile installation is thin-set mortar. It is a cement-based adhesive that provides strong bonding and durability for securing tiles to walls.
You need to put up cement board first then apply the tile. You can find on line DIY step by step instructions and pointers.
You will need about a bag of cement for this project. You will also need around 0.15 cu.m of sand.
Just the installation for a ceramic or porcelain tile will be around $3-$4 per sq ft for floor & $4-$5 for wall tiles. If you're talking marble, granite or slate it's gonna be in the $5-$6 per sq ft & $6-$7 for wall tiles.
not advised, wood expands too much