No
moments are defined as r x f. if you have member [x,y,z] and force [u,v,w] being applied to the end of it you take the cross product, [w*y-v*z,U*z-w*x,v*x-u*y]. if the member and force are perpendicular just multiply them and if it creates a clockwise rotation it is negative.
Take the slab out and pour a new one with the right slope. Rent a concrete saw and cut a few grooves in it making the groove deeper away from the house. This will let the water drain off of the slap and away from the house. If the slab is separate from the house, you might be able to mud jack it at the house and raise it enough to slop it away from the house. Mud jacking is not terribly expensive.
Its to do with tension, it doesn't take much strength to break it
Well, darling, the modulus of rupture formula is simply the maximum amount of stress a material can handle before it breaks. It's calculated by dividing the maximum bending moment by the section modulus of the material. So, in a nutshell, it's all about figuring out how much a material can take before it snaps like a twig.
how long does it take for bituman to dry outside
It clusters alot in your house, if left untreated, it will take over you body, eat your organs, and destroy your house So Dont let it Cluster Over .0005 Onces ;)
The force required to destroy a 4x4x4 stone marble cube depends on the material's compressive strength, which varies by type of marble but typically ranges from 70 to 140 MPa (megapascals). To calculate the force needed to break the cube, multiply the compressive strength by the cross-sectional area of the cube's face (16 cm²). Thus, the force could range from approximately 1,120 to 2,240 kilograms-force, depending on the specific type of marble and its condition.
force is not a think it is only in star wars
It'd be hard to do 2 takes for the video, wouldn't you think?But yes, 1 take to destroy the house.
15,000 pieces
This depends on the bone; to break a finger generally doesn't take much force, but your femur or your thigh bone is harder than cement!
550 lbs. of pressure
1.85N
25 newtons or 6 lbs
About 5 minutes by chopper.
a bit of force, not allot of force.
A lot.