answersLogoWhite

0

A putlog scaffold consists of a single row of standards with the inner edge of the platform as close to the wall as is practicable. The standards are connected by a ledger fixed with right angle couplers and the putlogs are fixed to the ledgers using putlog couplers.

User Avatar

Wiki User

10y ago

What else can I help you with?

Continue Learning about Civil Engineering

Can Victaulic coupling be used for undrground buried pipes?

Victaulic products have a long history of being used on underground piping systems.


When do you need stortz connection?

Stortz connections are used to connected lengths of fire department water supply hose, or to connect a fire pumper to a structure's sprinkler and/or standpipe system. They provide a 1/4 turn 'sexless' connection, which is normally faster and easier to complete than a threaded coupling. The type of connection used to supply a structure is regulated by the fire code that applies to the jusisdiction where the structure is located. Designers and engineers should consult with their local Fire Marshal to determine the correct type of connection for their local. Using this type of connection for fire department supply hose depends on the standard operating procedures for hose in place at the fire department. Designers and engineers should conact their Fire Chief's office to determine these procedures.


How do repair collapsed main sewer clay pipe?

You must find where the pipe is collapsed usually by snake in till you hit the break or uncovering the pipe till you find the break. Cut both ends of the break with a saw or chain cutter so you have a nice smooth end. Install a rubber coupling on both ends slid onto your clay pipe. Measure and cut a replacement piece of pipe to fit between, slide rubber boots over the seams and tighten. Be careful not to over tighten and rebreak the pipe. Sewer lines have little to no pressure so a snug tightening will do. Run water down line and look for a leak. Cover and silt in dirt and you are ready to go.


Related Questions

What are the types of coupling in software engineering?

control coupling content coupling common coupling data coupling external coupling message coupling


What are types of mechanical coupling?

There are many like flexible coupling, jaw coupling, sleeve coupling, tire coupling, pin and bush coupling, rigid coupling, etc


Which coupling gives the higher gain in case of amplifier - a Capacitor coupling b Impedance coupling c Transformer coupling?

transformer coupling


What is instructional material?

Instructional materials are kind of tools or equipments can help effectively the instruuctor in theory teaching classroom or in practical assessment e. g the physical angle swivel coupling, putlog clip for putlog tube fittings... Another exemple of a instructional material is one deteriorated punctured standard in scaffolding elements.


What is RC coupling?

rc coupling is a coupling that involves capacitor aand resistor


Which coupling gives high gain in case of amplifier?

no.transformer coupling gives higher gain


Which Coupling produces minimum interference with frequency response?

Direct coupling


What are the different types of couplings?

1)rc coupling 2)transformer coupling 3)direct coupling


Which type of coupling is least preferred?

Content coupling


What would be an equivalent to victaulic coupling?

· Gruvlok Coupling


Is fluid coupling is a flexible coupling?

yes,i think so.


What is function of coupling?

coupling is a computer program, which is meant for the maintenance of the cohesion , coupling is inversely proportional to cohesion. When coupling and cohesion is combined then it acts as support to the high readability and maintainability of a computer program.