it is 3 to 2
Dry cement in bags is stored in a dry place protected from the weather. For large construction sites this is usually a secure storage area. If you are talking about mixed cement (wet) or concrete, then it is not stored on a construction site. It is mixed off-site and carried to the site in large "cement mixer" trucks. The it is placed (or poured) prior to the initial setting time specified by the concrete manufacturer.
There is no reason to wet them.
get some hot macadam- jam it into the pothole, tamp it. done.
Cement skin is commonly referred to as "cement burn" or "concrete burn." It occurs when the skin comes into contact with wet cement, leading to chemical burns and irritation due to the alkaline nature of the material. Proper protective gear, such as gloves and long sleeves, is essential to prevent this condition when working with cement.
It's called Surface Bonding Cement. It has chopped fiberglass in it. How to use it: Build a footer. Stack the block uo on the footer in the shape of the building. Get the block wet on one side of the wall. Trowel a 1/8" coat of Surface Bonding Cement on that side of the wall. Go to the other side of the wall, wet it and trowel a 1/8" coat of Surface Bonding Cement onto the wall. Keep it damp for the next week so it gets a chance to cure properly. Remember, concrete hardens by chemical reaction, not by drying out.
Once all ingredients are thoroughly wet (no "streaks" of dry cement) and the "slump" is correct, it is fully mixed.
The wet mix has moisture in addition to the components that have been used. The dry mix only has the individual components with no moisture or water.
Cement can be produced by two process,Dry processWet processBoth the process differs - grinding and mixing of raw materials in wet or dry state.
Cement is manufactured by two process namely,Dry processWet processMostly wet process is widely adopted.
Daft question really! Should be what is the density of cement. Does the question mean cement ( dry powder), wet concrete, set concrete or what?
yes if u like
Cement board is installed in the same manner as dry wall. It is an alternative to green board and is a lot better in locations that have wet conditions like shower stalls.
Dry concrete weighs more than wet sand because concrete is denser and more compact than sand, even when wet. Concrete is composed of cement, sand, gravel, and water, which results in a heavier material compared to sand alone.
A mixture of flour and water can be cleaned with some wet or dry paper towels. If the mess is large use a wet/dry vacuum to suck up the mess.
Wet Cement - 2012 was released on: USA: 2012 (internet)
first sift all the dry ingredients then all the wet ingredients separetly (sugar included) then mix wet and dry ingredients barely until it is moist remember do NOT over mix, the batter should be slightly lumpy have fun :)
It makes a wet-like gray liquid that is similar to cement but it's actually like a wet type of cement.