bearing capacity is the capacity of soil or strata that can be able to sustain the load of superstructure in the unit of load per m2 either ton/m2 or KN/m2
bearing pressure is nothing but bearing capacity example when you apply 100 KN on a unit area, equal opposite pressure will rise from the soil.
load / area = bearing capacity
The link between CBR and bearing capacity if you get figures in CBR how can you link them to the bearing capacity in kPa, this is the link in soil testing.
Taken from a NASA paper (2010 ASCE Earth & Space, Robotic Lunar Geotechnical Tool);Bearing pressure (kN/m2) = 26.16CBR0.664NOTE: this is only an approximation as there is no real direct correlation between bearing pressure and CBR
4. End-bearing piles. Typical end-bearing piles aredriven through very soft soil, such as a loose silt-bearingstratum underlain by compressible strata. Rememberthis factor when determining the load the piles cansupport safely.5. Friction piles. When a pile is driven into soil offairly uniform consistency and the tip is not seated in ahard layer, the load-carrying capacity of the pile isdeveloped by skin friction. The load is transferred to theadjoining soil by friction between the pile and thesurrounding soil. The load is transferred downward andlaterally to the soil
A typical load bearing header will be 2 2x12s with a 7/16 plywood spacer between them.
difference between the manufacture of bricks and manufacture of tiles
The link between CBR and bearing capacity if you get figures in CBR how can you link them to the bearing capacity in kPa, this is the link in soil testing.
Difference between interest-bearing and non-interest-bearing note.
Taken from a NASA paper (2010 ASCE Earth & Space, Robotic Lunar Geotechnical Tool);Bearing pressure (kN/m2) = 26.16CBR0.664NOTE: this is only an approximation as there is no real direct correlation between bearing pressure and CBR
What is the difference between rated capacity and the nominal capacity
I do not know the answer.The difference between mass and capacity is that capacity is how much something can hold and mass is the weight of an object.
Hydrostatic 1)For pressurized supply of fluid an external pressure supply is used 2) speed is less 3)Design of bearing house is complicated 4)Initial cost is high 5) Load carrying capacity is high 6) It can be used as air bearings. hydrodynamic 1) Pressure for fluid supply is produced by relative moving motion of the parts 2) The cost is less 3)Design of bearing house is less complicated 4) speed is high 5) Load carrying capacity is less 6) Cannot be used as air bearings.
In axial bearing the most power force in the same direction as the axis of the shaft In radial bearing no.
the difference between frriction bearing and antifriction bearing kya jan ke karega maal pata dateing ja or as kar......... bye...........
Both are the same term for the same part.
There is a difference in the two. Suspension grease will be thinner and the bearing grease would be much thicker in density .
what is the difference between thrust and pressure?
floating bearing allows axial movement of the shaft. fixed bearing does not allow for axial movement of the shaft