0
If I am reading the question correctly, a load bearing wall was removed and replaced with a beam? Clear span, no post in the middle? If cracks are appearing, the beam that was used was not big enough. For any space of 8 feet or more, 2x12 and plywood should be used for the beam or an engineered truss used.
What else can I help you with?
Where do you normally use a reinforced wide strip concrete foundation?
A reinforced wide strip concrete foundation is used if the soil is soft or is of a low bearing capacity. This would not work for heavy or clumpy soil.
Allowable bearing capacity?
what the bearing capacity for weather rock
Define - No load bearing wall?
A wall bearing no load.
What is the link between CBR and bearing capacity if you get figures in CBR how can you link them to the bearing capacity in kPa?
The link between CBR and bearing capacity if you get figures in CBR how can you link them to the bearing capacity in kPa, this is the link in soil testing.
Do you need to reinforce the floor of a raft foundation?
If the raft foundation is subject to a uniform load (Water & oil Tanks ..etc) u may not be required to reinforce the floor, only a plain concrete or even well compacted earth is sufficient provided it 'll transfere the load safely i.e giving a pressure less than the allowable bearing capacity of the underlying soil. Only peripheral or ring beams of reinforced concrete is required under the tank walls. If the raft is supporting colmns/walls, then it's subject to knife loads & got to be reinforced.
Where do you normally use a reinforced wide strip concrete foundation?
A reinforced wide strip concrete foundation is used if the soil is soft or is of a low bearing capacity. This would not work for heavy or clumpy soil.
What are the primary functions of a reinforced concrete service core?
- Provide Load Bearing Structure for other members- Reticulate Services through - Fire Protection - Usually used to put a lift shaft in
Where use the reinforced brick in builing construction?
Reinforced bricks are commonly used in building construction for structural elements such as load-bearing walls, columns, and foundations. The reinforcement adds strength and helps withstand stress, making them ideal for supporting structural loads in buildings. They are especially useful in seismic areas where extra strength and durability are needed.
What causes a groan or moan in front end of a 97 Mercury Sable when driving?
I would have to say a front hub/wheel bearing would more than likely be the culprit you can further narrow it down to left or right by noticing if it gets louder when turning left or right at speed turn vehicle left which puts stress on right bearing if it gets louder bearing is bad same applies for turning right good luck
Do vibrations happen if you remove a load bearing wall?
Yes, vibrations can still occur if a load-bearing wall is removed, especially if the structure is not properly supported or reinforced. The remaining structure may become more susceptible to vibrations and movement, potentially affecting the stability of the building. It is crucial to consult with a structural engineer before removing any load-bearing walls to ensure the structural integrity of the building is maintained.
Is it bearing or baring gifts?
It is "bearing gifts" (as in "carrying" them).
Can a deck support the weight of a hot tub?
Yes, a deck can support the weight of a hot tub, but it depends on the deck's construction and load-bearing capacity. It is important to consult with a structural engineer or contractor to ensure the deck is properly reinforced to support the weight of the hot tub.
What is bearing crush?
Interference between journal bearing to bearing housing is called bearing crush.
Is banana a Seed bearing or spore bearing?
spore bearing
Are daisy's seed bearing or non seed bearing?
seed bearing
When bearing is greater than 180 how to calculate back bearing?
when bearing is greater than 180 In order to calculate back bearing subtract bearing from 360
What is a rod bearing?
Rod bearing (short for connecting rod bearing) Is the bearing where the connecting rod is attached to the rotating crankshaft.
