0
What else can I help you with?
What is a pistol lock?
Generally a pistol lock fits in the trigger housing to prevent the trigger from being pulled. Usually takes a key to open and close it.
How do you get a trigger lock off a gun without the key?
Take it to a locksmith. Ummm...thanks tips. To get a trigger lock off yourself that you have lost the key for, you can simply drill out the lock mechanism (where the key goes). A drill press is the best for this. For the combo locks with a sliding cover, you can just hit the cover sharply with a hammer and it will break the lock mechanism, releasing the lock. These trigger locks were made primarily to keep kids fingers off guns, not for national security.
Why is a trigger fish called a trigger fish?
tooks like a trigger Its dorsal fin looks liker a trigger and can lock into an upright position enabling it to secure itself into protective quarters like corals and crevices.
Is the trigger lock on the Remington 870 express approved by the department of justice?
No requirement that it has to be.
How do you start a lawnflite s990 petrol strimmer?
best to pump to the trigger about 30-40 times then put the choke and trigger lock on and keep pulling when she fires up and the revs start to die turn the choke of but leave trigger lock on and slowley press in the trigger to build revs until warm. about 40 seconds for the whole procedure
Cva hawken rifle parts list?
A CVA Hawken rifle parts list would include the stock, trigger guard, side lock, and side plate. Other parts would include the cap lock and trigger.
How do you reset an active headrest in a Hyundai genesis?
Note that the headrest need not be replaced in the event of deployment - merely reset.TSB09-80-0011.Remove headrest from seat and observe status of trigger lock. The trigger lock can be seenwithin the deployed headrest.If the trigger lock is unlocked, proceed directly to Step 3.If the trigger lock is locked, proceed to Step 2.2.Apply 12 Volts DC to the pin at A, while grounding the sliding shaft. At the same time push thetrigger lock by hand into the unlocked position. Disconnect power. The trigger lock will remain inthe unlocked position.3.Turn over headrest and lay down on aclean, flat surface4.Push the crash handle into the coverusing fingers5.Push cover6.Push cover until there is no gap.
Are trigger locks good for the US?
If used properly, trigger locks are a valid safety device. If used improperly, trigger locks can be a hazard, and may even cause death. Some lock/gun combinations are actually more likely to discharge accidentally than an unlocked gun. Trigger locks by and large are useless against thieves, but can be used to control child access. If a firearm is kept for defensive purposes, a trigger lock is not an appropriate choice for access control and other options should be investigated. Since so much depends on the circumstances and the particular user, along with wide variety in lock and firearm designs, a definitive answer is not possible. As always, the ultimate safety is between your ears. Do not rely on the presence of a trigger lock. Do not assume the gun is not loaded. Do not assume it will not fire. Do not handle firearms you are not familiar with, just because they have a lock on them.
Never use a circular saw that doesn't have a upper blade guard because?
trigger lock will not work properly
What is the model of a 38 caliber Forehand and Wadsworth handgun octagonal 2 barrel trigger patent date of April 3 1887 on trigger across top of the body it says double lock and safety hammer?
The Bulldog
What is the value of a jennings j-22?
I recently bought one from my uncle for $80. in excellent condition with two mags, trigger lock, and holster.
What years were the 001avt stihl made?
1989 still running good, some problem with the trigger lock. not sure how many years they were manufactured.
