0
What else can I help you with?
How can you tell the difference between a hydraulic lifter and a mechanical lifter on a Chevy 350 engine?
Take a pushrod and push down on the plunger in the lifter. A hydraulic lifter is spring loaded.
Would a worn out lifter cause a taping in the engine or do you need to shim a valve spring?
It is cheaper than replacing the lifter
What is the little rod between the rocker and valve spring call on a 3.0 Plymouth engine?
That is the hydraulic lifter
350 small block vortec heads the lifters rattle?
If it's actually the rockers arms that are "chattering" while the engine runs, you may need to adjust the lash. If there are Solid lifters in the engine, you may want to switch to hydraulic lifters and adjust the rockers to the moment of "zero lash". Adjust them in pairs per cylinder while the lifters are in the down position (both valves closed). When you reach zero lash on the rocker arm (the pushrod will suddenly stop spinning freely in your fingers) add an additional quarter turn to the rocker arm nut to set the "pre-load" of the lifter. This just means that the pushrod will be pushed down slightly in the spring loaded hydraulic lifter and when the engine runs, the oil pressure will keep pressure on the lifter and thus the rocker arms will run silently. More detailed info at BoxWrench.net if you need it...
How do you adjust lawn mower idle?
governor near air filter... don't adjust it too much or it will eventually blow the engine.. youtube has instructuions on how to properly adjust the spring
How do you set the load on the belt tensioner on a 1995 350 Chevrolet engine?
You can't, It is spring loaded and it adjust itself.
How is the cartridge lifter spring in a glenfield model 60 positioned in the trigger receiver group?
In the Glenfield Model 60, the cartridge lifter spring is positioned within the trigger receiver group alongside the cartridge lifter itself. The spring is typically mounted to provide upward tension on the lifter, ensuring it can reliably push cartridges into the chamber when the action is cycled. Proper alignment and positioning are crucial for the smooth operation of the feeding mechanism, allowing for consistent and reliable cycling of ammunition.
Where is the tensioner on a 1994 Dodge Grand Caravan with a 3.3L V-6 and how do you adjust it?
It is on the front ot the engine and it is spring loaded and not adjustable,.
How do you adjust the governor spring on a lawn boy?
To adjust the governor spring on a Lawn Boy mower, first, ensure the engine is off and cooled down for safety. Locate the governor spring, which is typically attached to the governor arm and carburetor. You can adjust the tension by either moving the spring to a different hole on the governor arm or by gently twisting it to increase or decrease tension. After making adjustments, start the mower and check for proper throttle response before making further changes if necessary.
How do you determine if a 1970's Chevy 350 has hydraulic or solid lifters?
You could take off a rocker and try to push down on the pushrod. You'd be able to feel the spring in a hydraulic lifter, but not on a solid lifter.
Where can you buy parts for a JC Higgins model 30 58374 22cal Looking for cartridge lifter spring?
We have them. gunshop@nctv.com
How do you tension timing belt on Mazda 1.8 dohc engine?
You don't. The timing belt should have a spring loaded tensioner which pulls on the belt to adjust tension.
