answersLogoWhite

0

Yes, a Nissan 1400 engine can be fitted onto a Nissan 720 4x4 gearbox, but modifications may be necessary for proper alignment and compatibility. The 720 gearbox was designed for a different engine, so adapting mounts, bellhousing, and possibly the driveshaft may be required. It's advisable to consult with a mechanic familiar with both models to ensure a successful installation.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

Can a 1.6 saxo engine fit a 1.1 106 gearbox?

Yes, the VTR does, not sure if all years do, but my 2001 1.1 gearbox fitted onto my 2003 VTR :)


Where is the starter on a 1991 Nissan 300zx?

the starter can be found by jacking up the front of the car and by going underneath the drivers side door you should be able to see it bolted onto your gearbox. has a bolt and a nut holding it on. and a positive12v connection bolted onto it aswell( which is alays live by the way)


Where are the exhaust manifolds on a 2000 Nissan Xterra?

The exhaust manifolds on a 2000 Xterra are bolted onto the side of the engine heads. The manifold carries the engine fumes to the exhaust pipes.


Where are the engine mounts on a Renault Scenic x reg?

as far as i know, there 2 on the top, 1 lef and 1 right, adn theres 1 engine stabilizer on the bottom of the gearbox onto the chassis, these are the ones that always go, dogbone stabilizer/engine stabilizer


How do you change a clutch on a Nissan Micra?

Remove airbox, drive shafts, all connectors onto gearbox, gear selector rod, battery and battery tray, starter motor and then all bolts securing the gearbox. Remove gearbos, and then remove the bolts securing the clutch. Fit new clutch making sure you allign the clutch plate. Refit everything in reverse.


How do you adjust clutch cable on Nissan N14 pulsar?

i have a n14 sss sr20de all i do is open bonnet right side of engine should see gearbox on top there is cable hooked onto clutch fork. were it hooks on to the fork thers like a bottle top screw u srew it towards the fire wall to tighten and towards front of car to loosen hope this helps


Where is the thermostat located on a rover 214?

Where the engine meets the gearbox there is a large metal water pipe on top with a bleed screw on it, under distributor. Follow that pipe right round the back of the engine and it will join onto the stat housing with 3 little bolts


Can you swap a h22 transmission onto a h23 engine?

yes because you can swap a h23 transmission onto an h22 engine


How do you go about removing the automatic gearbox from a 1990 Nissan 300 zx twin turbo?

This is not a job for the faint hearted and it is recommended to use a car lift. Firstly, disconnect the battery and drain the oil from the automatic gearbox. Inside car, remove the radio console and then the centre console to obtain access to the gearlever mechanism, which has to be disconnected.Mark the propshaft in relation to the diff flange prior to removal and ensure it goes back in the same position (it will vibrate like hell if it is not). remove exhausts downpipes and centre sections (may have catalystic converter fitted so sensors will need to be removed from them as well). Remove starter. Remove lower engine plate (bolts onto gearbox bell housing).remove bolts holding the torque converter to the starter ring plate. Disconnect wiring looms and speed sensor connections from box. Remove lower gearbox to engine fixing bolts. You are now ready to remove the bolts from the cross member that retains the box to the underside. Support the gearbox and remove these bolts. Gently lower the box to gain access to the bolts at the top of the gearbox bellhousing. One of them has an earth wire attached. Ensure that this is reconnected when refitting. You are now ready to remove the gearbox and the torque converter together, which will still be full of oil, so will be messy when seperated.


Is the 1995 Volkswagen transporter 2.5 petrol gearbox the same as 1999 petrol 2.5?

Simple answer is no. The way that diesel engines produce and use power is totally different to the way petrol engines produce power, the diesels power is at the bottom of the rev range as opposed to the petrol engines being at the top of the rev range. Becuse of this diesel engine gearboxes use very long gear ratios and petrol engine gearboxes use very short ratios. If you put a diesel engine onto a petrol gearbox the effect would be that in fifth gear at max revs you'll be travelling at 40mph.


Oil from the engine dripped onto the floor of the garage which is the complete verb?

dripped onto


What does an oil filter screw onto?

The engine block.