answersLogoWhite

0

Yes and No. Your tractor would have to be equipped with a three point hitch. Some backhoes had the option most did not.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What are popular styles of compact tractor attachments?

A compact tractor is a smaller version of an agricultural tractor and most commonly used attachments in compact tractors are front end loader and three point hitch.


What does puh mean as seen on ford tractors?

PUH means Pick-up hitch. One can hitch a trailer to the tractor without leaving the tractor seat.


Can I attach the Great Plains garden cart to my lawn tractor?

Yes, you need a tractor trailer hitch attachment if you do not already have one.


How does a tractor pull an object?

An object is connected to the tractor via a drawbar which connects the implement's hitch to the tractor by a simple pin which can be removed and used again. A chain can also be attached to this drawbar to connect an object w/o a hitch. The horsepower from the tractor's engine drives it's drive wheeles which cause it to pull the object forward.


Can you convert a bradco 609 skid steer backhoe to a 3 point?

Yes, it is possible to convert a Bradco 609 skid steer backhoe to a 3-point hitch configuration, but it requires specific modifications and the appropriate adapter kit. This involves removing the backhoe from the skid steer and installing a compatible 3-point hitch system that can accommodate the backhoe's hydraulic and structural needs. It's advisable to consult with a professional or the manufacturer for guidance to ensure compatibility and safety during the conversion process.


Can you install a Sleeve Hitch on 190C John Deere garden tractor?

NO! The 190c is a lawn tractor. Not a garden tractor. Sleeve hitches are designed for ground engaging and lifting attachments. Don't let those 23" tires fool you. Your rearend cannot handle that kind of load. It has bushings instead of bearings and they will wear out quickly if you don't burn up your transaxle first. That tractor is designed to mow and light snow pushing with a front blade. Also a small trailer would work well but that's it.


What is the tractor attachment for pulling weights?

Not completely sure what u mean but if u want to pull alot of weight the attachments you can use are: 1.Wheel weights ($40 used) 2.liquid filled tires (calcium or Rimguard type ballast) 3.Suitcase weights (expensive) 4.High hitch (u wont pull anything unless ur hitch is higher than the axle)


What are the dimension of a three point category 1 hitch?

The three point hitch refers to the way ploughs are attached to an agricultural tractor. The dimensions of a category 1 hitch is 3/4 inch x 7/8 inch.


Why does the 3 point hitch slip on your ford tractor?

The rings on your lift cylinder are bad or you are low on fluid.


How do you remove the hitch from a yo-yo to make it sleep?

you un do every thing and just put the loop on and that a non-hitch, and how does the hitch look you un do every thing and just put the loop on and that a non-hitch, and how does the hitch look


Where is the hydraulic dipstick on a SAME explorer tractor?

On a SAME Explorer tractor, the hydraulic dipstick is typically located near the rear of the tractor, often near the hydraulic reservoir. It can usually be found on the right side, close to the three-point hitch area. To check the hydraulic fluid level, you need to remove the dipstick, wipe it clean, and then reinsert it to get an accurate reading. Always consult the operator's manual for specific details related to your tractor model.


What size hitch would be used for a 2006 Dodge Ram?

The truck requires a 2 inch receiver. The attachments would be matched to the trailer.