answersLogoWhite

0

It weighs 4720 lbs and has a capacity rating of 1300 lbs.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you start a bobcat 743b?

with a key . ok i have a bobcat 743b and i climb in and first hold the glow plug button for ten seconds and than turn the key .


What year is a Bobcat Skid Steer 743B 5093 18675?

The Bobcat Skid Steer 743B with the serial number 5093 18675 was manufactured in 1995. The "B" in the model designation typically indicates the year of production within the Bobcat model lineup. For the most accurate information, it's always recommended to check the manufacturer's specifications or contact a Bobcat dealer directly.


What is the difference between a Bobcat 743 and a Bobcat 743B?

The Bobcat 743B uses propane as the engine's fuel source.The Bobcat 743 utilizes diesel as the primary fuel source. The difference between a 743 and 743B bobcat are undercarriage improvements and an improved bobtach mounting plate on the front of the loader for hooking up attachments. If you were looking for propane powered units try the 742 or 742B. The 742 has a Ford industrial 4 cylinder in it and the 742B has a Mitsubishi indutrial engine in it, both of which can be converted to run on propane. On the older machines the model number for example 743, the 3 means liquid cooled diesel engine


What is oil capacity for a 743b bobcat?

The oil capacity for a Bobcat 743B is approximately 3.5 quarts (or about 3.3 liters) for the engine oil. It's important to always check the owner's manual for the most accurate specifications, as oil capacity can vary slightly based on the specific model and any modifications. Additionally, ensure to use the recommended oil type for optimal performance.


How do you tighten drive chain on 743B bobcat skid steer?

To tighten the drive chain on a Bobcat 743B skid steer, first, locate the chain tensioner near the drive sprocket. Use a wrench to loosen the tensioning bolts, then adjust the tensioner to achieve the desired chain tightness. Once the chain is properly tightened, retighten the bolts securely. Always refer to the operator's manual for specific tension specifications and procedures.


Do i have to remove the manifold when taking out the glow plugs in 743b bobcat and how do you remove the glow plugs and with what tool?

no. just use a socket to remove after removing electrical connects between the glow plugs. this is assuming you have a 1702 kubota diesel. almost like removing a spark plug out of a gas engine. one glow pump is hard to get out. may have to remove a ejector feed line for clearance. hope this helps.