The dipstick and fill plug are located in front of the gearshifts on the right hand side of the transmission.
On a Ford 2600 tractor, the hydraulic dipstick is typically located on the left side of the tractor, near the hydraulic reservoir. It may be integrated into the fill cap of the hydraulic fluid reservoir. To check the hydraulic fluid level, remove the dipstick, clean it, reinsert it without screwing it in, and then pull it out again to read the fluid level. Always refer to the owner's manual for specific instructions and locations.
To replace the hydraulic filter on a Massey Ferguson 2600, first, ensure the tractor is turned off and parked on a level surface. Locate the hydraulic filter, which is typically near the hydraulic pump or reservoir, and place a drain pan underneath to catch any fluid. Unscrew the old filter using an appropriate tool, apply a thin layer of hydraulic oil to the gasket of the new filter, and install it by hand until snug. Finally, refill the hydraulic system if necessary, and check for leaks before starting the tractor.
Here's a link to everything you ever wanted to know about the Ford 2600 tractor, and more. http://www.tractordata.com/farm-tractors/000/2/5/257-ford-2600.html
Try this Site; http://www.tractordata.com/farm-tractors/000/2/5/257-ford-2600-engine.html
The gasoline model produced around 20 h.p.
The firing order for 3 cylinder gas is 1-2-3
20% of 2600= 20% * 2600= 0.2 * 2600= 520
3.50 percent of 2600 = 913.5% of 2600= 3.5% * 2600= 0.035 * 2600= 91
2600 = 1 x 2600 2600 = 2 x 1300 2600 = 4 x 650 2600 = 5 x 520 2600 = 8 x 325 2600 = 10 x 260 2600 = 13 x 200 2600 = 20 x 130 2600 = 25 x 104 2600 = 26 x 100 2600 = 40 x 65 2600 = 50 x 52
The Tuner Monster with the highest ATK and Level is Emissary from Pandemonium (7/2600/1800).
0.8% of 2600= 0.8% * 2600= 0.008 * 2600= 20.8
18.5% of 2600= 18.5% * 2600= 0.185 * 2600= 481