To engine kill a CAN bus, you can send a specific CAN message that instructs the engine control unit (ECU) to shut down or enter a safe mode. This typically involves sending a command that sets the engine's operating parameters to zero or activates a shutdown routine. Alternatively, you can physically disconnect power to the ECU or interrupt the CAN bus communication by isolating the relevant nodes. However, it's important to note that manipulating the CAN bus without proper authorization or knowledge can lead to unintended consequences and may violate legal regulations.
"The bus's engine stopped after the alternator belt snapped under the hood."The possessive noun is bus's (the engine of the bus).
Mainly, yes, but there are minor differences, and of cource the bus engine is usually largest :)
You would have to know the size and type of engine, the age of the engine, the age of the bus and weight of the bus. As a general rule, a diesel engine on a bus would get around 6-15 miles per gallon.
Tanks, frags, and mostly guns.
The bus that the Chinese are currently developing is rear engine motor bus. This engine allows the vehicle to move at faster speeds and get to places faster.
A typical school bus engine can take anywhere from 10 to 30 quarts of oil, depending on the size and model of the bus. It is recommended to consult the specific bus owner's manual for the correct oil capacity.
engine
Key has to be on but engine doesn't have to be running.
It means the engine is in the rear of the bus or RV.
It depends on what you're trying to say. "In the bus" means that you're inside, or it could refer to a part of the bus that's inside the engine. "On the bus" can mean that you have gotten on the bus and are riding it, or it can mean that you're on top of it!
benjamin franklin
1963