just unscrew the two wheel locating lugs on the drum (make sure the handbrake is off) give the drum a gentle tap with a hammer and it will come off with a bit of wiggling, however if the drum is seized on the best option is to screw 3 x10mm bolts into the drum, these holes are located in-between the holes for the wheel nuts, screw them in alternatively so the drum comes away evenly
To replace the rear brake shoes on a Fiat Ducato van, first, lift the vehicle and remove the rear wheels. Then, remove the drum by unscrewing the retaining screws and gently pulling it off. Take out the old brake shoes, noting their arrangement, and replace them with new ones, ensuring the springs and adjusters are correctly positioned. Finally, reassemble the drum and wheel, then lower the vehicle and test the brakes before driving.
Fiat Ducato was created in 1981.
how to top up fiat ducato gearbox
Where is the glowplug relay on a fiat ducato 2003 1.9
what is the weight of fiat ducato 2.8
There's a relay and fuse in the fuse box in the engine compartment.
The first Fiat Ducato was produced in 1981. Since then more than two point four million Fiat Ducato vehicles have been produced. It is the most common motor home in Europe.
To fit rear brakes on a Fiat Ducato, start by lifting the vehicle and securing it on jack stands. Remove the rear wheels and then detach the brake caliper by unbolting it from the mounting bracket; support it with a wire to avoid stress on the brake line. Replace the brake pads and any necessary components, then reassemble the caliper and ensure everything is tightened to the manufacturer’s specifications. Finally, reattach the wheels, lower the vehicle, and pump the brake pedal to seat the new pads before taking a test drive.
what gearbox oil for ducato 2.8 jtd
tony
I have a Fiat Ducato 2.5td on a 1997 plate. It does not have glow plugs.Just a Thermo Start on top of the manifold, this is similar in looks to a glow plug but is easier to get to. Be careful as you have to remove the Fuel pipe from the Thermo Plug, take you time.Hope this helps.
what are the pins for on a wheel drum?