answersLogoWhite

0

The spring clamping the two wires must be compressed to release the wires. the 1/4" screw and clamp need to be taken loose first. You would be advised to replace the coil with a solid state armature as the best option, however.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Should you replace condenser and points on a 6hp Briggs Stratton engine?

If they are bad, then yes. If not, then don't bother replacing them.


How do you replace ac condenser on a 2001 Chevy Venture?

How do you replace ac condenser on a 2001 chevy venture?


Can an electronic ignition be used in lieu of points and condenser on Briggs and straton engine?

yes


How do you install points and condenser on Briggs and stratton model 195437-0150-01?

To install the points and condenser on a Briggs and Stratton model 195437-0150-01, first, remove the flywheel by loosening the retaining nut and using a puller if necessary. Once the flywheel is off, locate the points and condenser assembly; remove the old components and replace them with the new parts, ensuring the points are properly gapped according to the specifications. Reassemble the flywheel, making sure everything is aligned correctly, and then test the engine to ensure it runs smoothly. Always refer to the engine's service manual for specific instructions and specifications.


Where to find step by step instructions to replace the air conditioning condenser in a 2005 gmc canyon?

Drain the cooling system.Remove the radiator.Recover the refrigerant.Remove the receiver dryer.Remove the condenser inlet hose bolt.Remove the condenser inlet hose.Remove the condenser outlet hose bolt.Remove the condenser outlet hose.Remove the condenser from mounts on the radiator.Remove the condenser...........................


How do you replace a Condenser for a 2006 f350?

To replace the condenser on a 2006 F350, begin by disconnecting the negative battery terminal to ensure safety. Remove the front grille and any components obstructing access to the condenser, such as the radiator and fans. Disconnect the refrigerant lines from the condenser, ensuring to recover any refrigerant properly. Finally, unbolt the condenser from its mounts, replace it with the new unit, and reassemble all parts in reverse order, ensuring to recharge the AC system afterward.


What to replace Briggs and stratton engine model 902004?

that is not a good model number for briggs. also you need the type.


How do you replace ac condenser in a 03 Mitsubishi eclipse?

Unscrew radiator, should be two attachments connected to condenser. Unscrew them from the condenser and it should slide right out from in front of the radiator.


How do you change a condenser in a 2001 Kia Sephia?

To change a condenser in a 2001 Kia Sephia you need to disconnect the refrigerant lines and unbolting the condenser. Lift the condensers out and replace with the new one.


How do you replace a air condition condenser step by step on a 1996 Chevrolet 1 ton dually?

how do you replace an air condition condenser step by step on a 1996 Chevrolet silverado 1 ton dually?


How to clean plugged condenser venture van?

I believe it would be less expensive to just replace the condenser. The labor rate to remove it, clean it, then replace it would be the same whether you TRY to unplug it or just replace it with a new one.Take Care,Greg


How do you replace condenser on a 2004 toureg?

To replace the condenser on a 2004 Touareg, start by disconnecting the battery and draining the refrigerant from the AC system. Next, remove the front bumper and any components obstructing access to the condenser, such as the radiator. Detach the condenser from its mounting points and disconnect the AC lines. Finally, install the new condenser by reversing the disassembly steps, ensuring all connections are secure and recharging the AC system afterward.