on the upper ball joints just remove the four bolts on the upper control arm and use a picker fork to remove the balljoint from the steering knuckle. for the lower ball joints you have to remove the axle then repeat the same steps for the uppers
look in front of the passenger rear tire disconnect both hose clamps and wires and remove from bracket ,also replace fuel filter
1969 Holden HT does not have king pins they have upper and lower arms with inner pivot bushes and outer ball joints
There are no king pins on these models.....if my memory serves correct they stopped using kingpins either in 79 or 80.....ball joints is what they switched to
My 1985 Nissan king cab ;)
6 X 9 on the front doors and 6 1/2 on the rear.
Inside a frame rail in front of the right (i think) rear tire.
You need a new heater core.
Nissan Figaro
McDonalds, Burger King
yes it is.
Do you mean clutch slave cylinder,if so ,its bolted on side of transmission,with rubber cover,if leaking,replace and bleed.
Yes