The fuel sending unit is inside of the tank. The unit has a float that is connected to a variable resistive device that sends a signal to the gauge to show the fuel level.
Inside the fuel tank. It is attached to the fuel level sender that is part of the fuel filler neck.
Oil pressure sender /fuel pump switch for 1995 Pontiac transport 3.1 is located between oil filter and starter at front of engine.
I suspect that the sender is bad or the wiring to it. The fuel sender is mounted along side the fuel pump which is located in the fuel tank. If your pump was just replaced maybe the sender was damaged in the process. It may just have gone bad also.
In the gas tank. Book procedure for replacing: Remove the negative battery cable. Relieve the fuel system fuel pressure. Remove the rear compartment trim panel - Rear in Body Rear End. Remove the nuts retaining the fuel sender access panel. Remove the fuel sender access panel. Disconnect the fuel sender electrical connectors. Clean the fuel pipes and the fuel sender assembly to prevent fuel contamination during the removal. Disconnect the quick-connect fittings at the fuel sender assembly. Remove fuel sender snap ring retaining the fuel sender. Remove the modular fuel sender assembly. Clean and inspect the O-ring sealing surfaces of the fuel sender assembly . Important Always replace the fuel sender O-rings when reinstalling the fuel sender assembly. The modular fuel sender assembly will spring-up when the snap ring is removed. When removing the modular fuel sender assembly from the fuel tank, the reservoir bucket on the fuel sender assembly is full of fuel. The modular fuel sender assembly must be tipped slightly during removal in order to avoid damage to the float. Place any remaining fuel into an approved container once the modular fuel sender assembly is removed from the fuel tank. Always maintain cleanliness when servicing the fuel system components. Care should be taken not to fold over or twist the fuel pump strainer when installing the fuel sender assembly, as this will restrict fuel flow. Also, ensure that the fuel pump strainer does not block full travel of float arm. Ensure that the snap ring retaining the fuel sender assembly is fully seated within the tab slots on the fuel tank. Position the new fuel sender assembly O-ring on the fuel tank. Install the fuel sender assembly into the fuel tank. The Fuel Sender Assembly is spring loaded, it will be necessary to hold the sender in place. Install the snap ring retaining the fuel sender assembly . Connect the fuel sender assembly electrical connectors. Install the quick-connect fittings at the fuel sender assembly. Connect the negative battery cable. Perform the following procedure to check for fuel leaks: Turn the ignition switch to the ON position for 2 seconds. Turn the ignition switch to the OFF for 10 seconds. Turn the ignition switch to the ON position again. Visually inspect the fuel system for fuel leaks. Install the fuel sender access panel. Good Luck!
The fuel filter is located in the fuel sender assembly, inside the fuel tank. Vehicles with dual tanks, have no fuel filter in the rear tank fuel sender assembly.
hi mate the fuel sender on the corsa should be in the fuel tank as on the majority of cars cheers telboy.
fuel gauge sender and pump are in the gas tank (which must be removed).
Fuel pump
fuel stop relay
The fuel sensor on a 1995 Chevrolet Beretta is located within the fuel tank. Specifically, it is part of the fuel pump assembly, which includes the fuel level sender. To access it, you typically need to remove the rear seat and the fuel tank access cover, or alternatively, drop the fuel tank itself. Always ensure to follow safety precautions when working with fuel systems.
3
Inside the fuel tank.....