answersLogoWhite

0

harrow, disc, plow, cultivator, hay spear, baler, hoist, box blade, front loader, rear bucket, straight blade, auger, bush hog, log spliter, bale carrier, finish mower, feterlizer aprayer, rake, spring tooth,tiller,swather hay rake im sure much more.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Does a lawn tractor have a fuse?

Yes,its attached to red wire on battery


When operating an electric pallet jack before entering a trailer that is not is not attached to a tractor always make sure that answer it?

when operating an electric pallet jack before entering a trailer that is not attached to a tractor always make sure that answer it


What is the oil capacity of a Kubota T1670 lawn tractor engine?

I attached the specs sheet for you.


Sears Tractor runs only with jumper cables attached to a good battery After disconnecting the cables the tractor engins within seconds It's a 17 Hp Kohler engin on a Sears 42 mower tractor?

If the tractor had a battery in it when you were jumping it, there is a chance that the battery is bad. Try unhooking the tractors battery and trying again. Hook your jumper cables to the battery cables themselves without being attached to the battery. If it runs then just replace the battery. A battery with a short in it will keep the mower from charging and could cause it to die. If there was no battery in the tractor when you were jumping it, then the tractor is not charging and will have to be diagnosed as to what the problem is.


How do you connect a battery on a tractor?

1. Locate the tractor battery cables. 2. Follow each cable to where it connects to the tractor. One cable will be connected/attached to the tractor chassis/frame. The other cable will be connected/attached to the tractor starter motor. If you don't find this to be true, then discontinue this procedure now. 3. Connect the unconnected end of the cable that is connected to the starter motor to the "+" or "pos" battery post. 4. Connect the unconnected end of the other cable that is connected to the tractor chassis/frame to the "-" or "neg" battery post. 5. Snugly tighten the post connector nuts to ensure a firm/stable electrical connection. Done. Your battery is now connected to your tractor properly.


How does a tractor pull an object?

An object is connected to the tractor via a drawbar which connects the implement's hitch to the tractor by a simple pin which can be removed and used again. A chain can also be attached to this drawbar to connect an object w/o a hitch. The horsepower from the tractor's engine drives it's drive wheeles which cause it to pull the object forward.


When operating a forklift before entering a trailer that is not attached to a tractor what should you check?

Make sure that the trailer wheels are chocked.


Where is the serial number located on a Nortrac NT 254 tractor?

The serial number on a Nortrac NT 254 tractor is typically located on the frame of the tractor, often found on the left side, near the rear axle or on the engine block. It may also be stamped on a metal plate attached to the tractor. For precise location, it's advisable to consult the tractor's user manual or contact the manufacturer directly.


What do PTO abbreviation stand for?

Power Take Off - the power extension mechanism on a farm tractor or similar vehicle that extends mechanical power from the engine out to different implements attached to the tractor. OR Parent-Teacher Organization


What do you call a horse tractor?

I have had horses almost my whole life and I have never heard of a horse tractor. There are tractors used on ranches or farms such as small tractors with a bucket on the front for scooping manure and bedding. Maybe this is what you are thinking of. This same tractor can be attached to a 'drag' and can be used to groom or drag riding arenas. There are many uses for this type of tractor on horse farms.


Where is serial number on Gibson model D tractor?

On a Gibson model D tractor, the serial number is typically located on the left side of the engine block or on the frame, often near the front or rear of the tractor. It may also be found on a metal plate attached to the tractor. Always refer to the owner's manual for specific details, as the location can vary by model year.


Which farm tractor parts do I need to purchase for a pig farm?

Depending on the size of your pig farm, would depend on the size of tractor you would need. For example, a John Deere farm tractor in the 5000 series can handle around 40 acres, and can be attached to about 260 accessories for all your farming needs.