NOTICE: The information contained on this site is presented for information only. OBD-Codes.com is not responsible for any actions you take on any vehicles. If you have any doubt as to repairs on your vehicle, please contact a qualified technician. Lack of HO2S-21 Switch, Sensor Indicates Lean A Heated Exhaust
Oxygen (HO2S) sensor indicating lean at the end of a test is trying to correct for an over-rich condition. The test fails when the fuel control system no longer detects switching for a calibrated amount of time. You will likely not notice any drivability problems. A code P1151 may mean that one or more of the following has happened: * Short to VPWR in the harness or HO2S * Water in the harness connector * Open/shorted HO2S circuit * Corrosion or poor mating terminals and wiring * Damaged HO2S * Damaged PCM * Excessive fuel pressure
Leaking/contaminated fuel injectors
Leaking fuel pressure regulator
Low fuel pressure or running out of fuel
Vapor recovery system * Air leaks after the MAF * Vacuum Leaks * Improperly seated engine oil dipstick * Leaking gasket * Stuck EGR valve * Leaking diaphragm or EVR * Oil overfill * Cam Timing * Cylinder compression * Exhaust leaks before or near the HO2S(s) * See the above list of causes and go from there. Sources: MotorCraftService.com
Take it to a Chevy dealer and get it fixed, ford will only mess you over.
2012 ford e-250 radio removal
The curb weight for a Ford E 250 will vary depending on the model and year. A 2009 Ford E 250 has a curb weight of 8,900.
Ford still makes the E-250 van. It was the E-150 they stopped making, I think around 2002-2004
one
Where_is_locate_spark_plug_ford_2001_van_E-250
According to the 2000 Ford E - 250 owners manual ( 5 w 30 engine oil )
How do you change the front brake pads on a Ford E-250 van? cannot remove the pads from assembly.
On a 2003 E-250 4.6 liter V8 : 4 - 8 3 - 7 2 - 6 1 - 5 front of Ford E-250 , V8
On a 2003 Ford E-250 : Open the drivers door and on the end of the door ( or the latch pillar ) you will see an information sticker . One of the things it normally shows is the axle code ( under " AXLE " )
The axle code 22 for a 2007 Ford E-250 indicates that the vehicle is equipped with a 3.73:1 axle ratio. This is a common configuration for models designed for towing or carrying heavier loads, as it provides a good balance of power and fuel efficiency. The code helps identify the specific axle type and ratio used in the vehicle, which can be important for maintenance and replacement parts.
According to the 1998 Ford E-250 Owner Guide : You could either have a ( 5 lug wheel ) or an ( 8 lug wheel )