answersLogoWhite

0

i have a 1988 4610su II same engine as 4610 theres a site tractor data that answers alot of questions about tractors all makes and models it says the engine oil cap for the 4610 is 7 quarts the orginal oil was a straight 30 wgt but 15w40 is also reccommended and is what most farmers ar now using due to better starting in cold weather hope this helps have a good day

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you check oil 4610 ford tractor?

The oil tube on a 4610 Ford Tractor is located under the hood. There is an oil stick included to help check the level of the oil.


Where do you add hydraulic fluid to a ford 4610?

In a Ford 4610, you need to add the hydraulic fluid to the rear axle. The Ford 4610 is a 1989 tractor that retailed at close to $19,000.


Where do you add hydraulic fluid to a ford 4610 tractor?

in the back axle


Where do you add powersteering fluid to a ford 4610 tractor?

right by the oil


How do you remove starter from ford tractor 4610?

To remove the starter from a Ford Tractor 4610, first disconnect the negative battery cable to ensure safety. Then, locate the starter, which is typically mounted on the engine block. Remove the electrical connections and the mounting bolts securing the starter in place. Finally, carefully extract the starter from its housing.


Ford 4610 tractor Where is third bolt on starter?

Right behind the solenoid. Have to feel for it of use mirror.


Is there a Ford Model 4810 diesel tractor?

Yes. The Ford 4810 was built in the United Kingdom, mostly for export. It was a Ford 4000 chassis, but swapped out the three cylinder motor of the 4610 for a four cylinder motor. However, it was sold in the UK as the 5030, rather than the 4810.


How do you crank a ford 4610 tractor after changing the fuel filter?

What I have done to bleed the lines in my 4810 Diesel after changing the fuel filter is this.. 1. Obviously, bleed the filter housing to get the filter primed and the air out. 2. If the tractor won't start...i will swing the battery out exposing the injector lines into the block...while cranking the engine over, loosen each injector line one at a time until fuel seeps from the fitting, then re-tighten while it is pumping. Usually by the time you bleed the 3rd injector, the engine will fire up... *Obviously...safety is paramount...make sure tractor is in neutral and parking brake is engaged.


What is 4613 rounded to the nearest ten?

4610


What is 4610 rounded to the nearest ten?

4610


What is 4610 as a mixed number?

4610 is an integer, not a mixed number.


The least number of 5 digits which is excately divisible by 4610 and 15 is?

13830 = 4610*3 and 15*922