Spark plug gap 0.8mm
Spark plug tightening torque 20Nm
Poits gap 0.50mm
Distributor dwell angle 49 to 55 degrees
Ignition timing 7 deg BTDC in neutral
Valve clearance - adjust when hot
Inlet 0.35 mm
Exhaust 0.35mm
Fanbelt tention deflection 8 to 12 mm
Tappet gap 0.4 to 0.5 mm
TORQUE
Cylinder head bolts 70 to 74 Nm
Connecting rod nuts 37Nm
Flywheel bolts 88Nm
Main bearing cap bolts 59Nm
Camshaft sprocket 47Nm
Camshaft Locking plate 8Nm
Sump bolts 6 Nm
Oil strainer bolts 14Nm
Crankshaft pulley bolt 196Nm
Rocker pedestal bolts 25 Nm - THESE TEND TO BREAK VERY EASY 20Nm and then 25NM
Valve rocker adjusting nut 22 Nm
Sump plug 29Nm
Tyre Pressure
155 SR 70 / 12 2 bar all round UNLOADED
The spark plug gap for a Nissan 1400 bakkie is typically around 0.7 to 0.8 mm (0.028 to 0.031 inches). It's important to check the owner's manual or service specifications for the exact gap required, as it may vary depending on the engine's model year and specific configuration. Properly setting the spark plug gap ensures optimal engine performance and fuel efficiency.
the typical gap(unless the engine has been modified) is .45. i hope this helps
The engine specifications of the Nissan Juke are 188 horse power with 32 miles per gallon with a turbocharge engine. These specifications are valued at a price of $25,000 but is sold for just under $20,000.
The firing order for a four-cylinder Nissan 1400 truck is 1,3,4,2. The plug wires should be attached in a counter-clockwise manner.
Some specifications for the Nissan Silvia S15 are 250 horsepower engine and 165 horsepower from its non-turbo range. Other specification of this Nissan is the interior and exterior style, which has been brought up to a modern style.
The technical specifications of generators from Northern Tool and Equipment vary dependent on the model of generator bought. Their maximum speed, fuel capacity, engine displacement and power vary according to the model of generator.
How do I switch off engine light off my 2003 opel corsa bakkie 1.4
There are many 1.6L Nissan engines. To get the correct specifications engine model/code is the most accurate information required/alternatively type of car, for example Nissan Pulsar and month/year of manufacture.
i did my bakkies engine just over a year ago, at some company but they did'NT do my head.the bakkie doesn't pull like a 1400 should. what can be wrong
For optimum performance, you should use high-test or premium gasoline in your Nissan Pathfinder, as per Nissan's specifications. Using a lower octane gasoline can result in premature ignition which can in the long run damage your engine.
The Nissan Skyline engine is the Nissan RB engine.
The 1991 Nissan Stanza typically comes with a 2.4L inline-4 engine. The head bolt torque specifications for this engine are generally around 75 ft-lbs (102 Nm) in a specific sequence to ensure even pressure. It's important to refer to the vehicle's service manual for precise torque sequences and specifications, as they can vary based on the engine variant. Always ensure to use a torque wrench for accuracy when performing such tasks.