0
Depends on which chassis it was built on. Blue Bird used Ford, Navistar International, and their own proprietary chassis (and probably some others, as well). In most cases, where the dash normally would be on the passenger side, there'll probably be a fuse panel there, with a small metal door to access it.
What else can I help you with?
Where is the fuse panel located on MCI 9 buses?
The MCI 9 buses are used as coach rides, travel buses, and party buses. The product manual or owner's manual will show the parts of the bus and the locations. The fuse panel location on the MCI 9 bus can be found by using the manuals.
Why is there no communication between the computer and the scanner on a Jeep Cherokee 1998 sport?
the CCD bus in the instrument panel is bad
How wide is a1989 FORD B BLUEBIRD 72 PASSENGER BUS?
96 inches
What type panel does a 4 pole breaker require?
The panel and breaker have to be of the same manufacturer. This way the breaker will fit into the panel. If the panel has a push in bus bar, the breaker must also be the type to accept the bus bar. If the bus bars in the panel are of the bolt in type then the breaker also has to be a bolt in breaker.
What car manufacturers make minibuses?
No regular car manufactuers make minibuses but the bus company Bluebird makes them
Where is the fuse box in a 1991 Toyota coaster bus?
In a 1991 Toyota Coaster bus, the fuse box is typically located under the dashboard on the driver's side. You may need to remove a panel or cover to access it. Additionally, there might be another fuse box located in the engine compartment for specific electrical components. Always refer to the owner's manual for precise locations and diagrams.
When was Higer Bus created?
Higer Bus was created in 1998.
Find the fuse box located on a 1996 Toyota bus?
Toyota previa fuse box located in the top center of the dash. look near where the air conditioning switch should be. you will see a small tab press this and lift the entire top panel up
How can you determine if a bus fuse is blown?
To determine if a bus fuse is blown, visually inspect the fuse for a break in the metal filament inside. If the filament is broken, the fuse is blown and needs to be replaced. Additionally, you can use a multimeter to test the continuity of the fuse to confirm if it is functioning properly.
When was Melbourne Bus Link created?
Melbourne Bus Link was created in 1998.
When was Das Bus created?
Das Bus was created on 1998-02-15.
What do I do if there is no circuit breaker for outdoor light?
If you have a light that is not being powered through a circuit breaker or fuse, you should call a qualified electrician to remove this circuit from the panel's bus and install a circuit breaker for it. Without an overcurrent protective device (circuit breaker or fuse) you have a potential fire hazard.
