In general the heater blower motor speed resistor is located in close proximity to the blower motor.
where is the blower motor resistor located on a ford e250 2001
The blower resistor is usually found attached to the A/C-heater box under the hood.
mounted on the a/c unit near the fan for heater under the hood
Why would you post this no brain question? Go ask your car dealer.
It is on the Right side of the Heater Core Covering.
Drop the glove box door; I believe you will then be able to see it. when you drop the glove box. the dog house is there. this is a van.
To replace the resistor heater blower in a 1994 Chevy van, first disconnect the vehicle battery to ensure safety. Locate the blower motor resistor, which is typically found near the blower motor under the dashboard on the passenger side. Remove the screws or bolts holding it in place, disconnect the wiring harness, and then replace it with the new resistor. Reassemble everything, reconnect the battery, and test the blower to ensure it operates properly.
to the left of the blower motor. It's on the left side of the engine compartment
Open the hood and it is on the left (passenger) side near the coolant reservoir.
Blower fan inoperative or only works on high speed.
Normally the wires and plug in can be purchased at the GM dealership. Will have to cut the wires back if they are melted and solder the wires together. Can also use a heat shrink butt connector to connect wires. Recommend the heater resistor be replaced and the heater blower motor be checked for wear or noisy bearings.
resistor usually located by blower motor.blower only works on low or high,then replace resistor .do not replace hvac unit in dash waste of time and money