Sequencer is out of sequence
Sequencer is out of sequence
A delay in restarting a compressor that is out on internal overload typically occurs to prevent potential damage to the unit. When a compressor trips due to internal overload, it indicates that the motor is overheating or experiencing excessive current draw, often due to issues like mechanical failure or inadequate lubrication. Restarting it too soon can exacerbate these problems, leading to more severe damage. Therefore, waiting allows the compressor to cool down and ensures that any underlying issues can be addressed before attempting to restart.
Sequencer is out of sequence
A time delay fuse will not blow at the first sign of an overload. It will delay blowing just long enough to allow a motor to start or a compressor to startup.
Overdrive, Delay and a Compressor.
Yes, if there is an anti recycle time delay in the unit. No if there is not. If there has not been sufficient time since the last off cycle and a new on command for the refrigerant pressures to equalize, the compressor will attempt to start but will fail several times on it`s internal overload protection device until the pressures are equal before it finally does start. Giving the appearance of a time delay, this situation however should not affect either the indoor or outdoor fan. So if there is a delay on the indoor fan starting, there is probably a delay timer which may even be built into the thermostat.
No, you do NOT earn credits for restarting and completing an island in poptropica.
The future tense of delay is will delay.
Its the same as Restarting your PC, your Mobile Phone,, etc Just switch it off and then switch On.
In order to keep your home air conditioning from restarting right after it stops raise the temperature on the thermostat. This will keep it from restarting so soon after it stops.
Some units have an on delay relay. This is installed to protect the compressor when a short cycling or quick on and off shuch as when the power blinks on and off. When the compressor is running it can build up a lot of pressure and be hard on the motor to start. The delay gives time for this pressure to dissipate. Often there is an adustment on the relay from around 0.3 sec. to around 10 min.