Did you..
- plug it in ?
- hook up the power ?
- on what device are you using those speakers ?
- Is it ON ?
_ If its a computer .. Is the sound card detected ?
Make sure the volume on the speakers is turned up, also the volume icon on the task bar should be turned up. Before all That If the sound card is on the motherboard make sure its enabled in BIOS, and all the drivers are installed, you can do that from device manager, If all that is OK uninstall the sound driver and re-install it. if its a PCI sound card uninstall it , Restart your computer and re-install the driver.
Check your cords. Make sure everything is connected that should be.Check the bottom right of the screen make sure your not muting. Check the audio volume of the music player.Troubleshoot your speakers.
Nope - if your sound is coming from both the headphones and the built-in speakers, it's your headphone socket in the laptop - not the plug that's at fault ! Basically an audio socket is a switch. While no external speakers (ie headphones) are connected, its internal components direct the sound to the computer's built-in speakers. Inserting a plug into the socket breaks the connection to the internal speaker circuitry, and directs the sound to the headphones.
Output devices are devices that present data coming from the computer. Speakers do this by taking information that is sent to it via the sound card and outputting that information via sound.
Sound configuration is the setup of your sound card, volume, and speaker arrangement.
speakers vibrate farther
By turning up the volume knob on a stereo system, the electrical signal that controls the speakers is amplified, resulting in an increase in the sound output heard through the speakers. This amplification boosts the strength of the audio signal, causing the speakers to produce louder sound waves.
Turning up a stereo increases the electrical signal being sent to the speakers, which in turn vibrates the speaker cones more vigorously, producing louder sound waves. This amplifies the volume of the sound heard.
If you turn the sound up too high on your stereo system, you can damage the surround sound speakers. Your speakers have a maximum amount of power they can handle from the amplifiers, and if you turn the volume up too high, you are giving the speakers too much power.
Turning up a stereo increases the electrical signal sent to the speakers, causing them to produce a greater physical vibration. This results in louder sound waves being produced, which are then heard as increased volume.
Using the volume knob.
plug in your speakers
Turn up the volume.
Volume refers to the loudness or intensity of a sound. It is determined by the amplitude or height of the sound wave - the greater the amplitude, the louder the sound. Volume is typically measured in decibels (dB) and can be adjusted using volume controls on devices like speakers or headphones.
No if you don't want sound turn the volume down for your speakers.
The next step should be to check the physical connections between your speakers and the audio source to ensure they are securely plugged in. It's also a good idea to test the speakers with a different audio source to rule out any issues with the original source. If these steps do not resolve the issue, it may be a problem with the speakers themselves and further troubleshooting or repair may be necessary.
Because the computer speakers (On the bar at the bottom) and the wired speakers both have to be on. If one is off and one is on, it will not work. Be sure both speakers are on and are close to the same volume.