answersLogoWhite

0


Best Answer

You can go to your local computer and network builder and see what he has in stock and try to match it to your bays. Trying to get a bespoke one is going to be prohibitively expensive. Ripping one off an old case might well be your only option.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you buy a front panel for a homemade computer case or do i have to rip one out of and old case?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Computer front panel wire color?

Most computer manufacturers do not follow a standard when it comes to front panel connector wire colors. The best place to locate such information is on the system's documentation. If you are building the computer on your own, the literature that came with the computer case might have what you are looking for. Many computer case manufacturers label the front panel connector cables individually so you can tell which wire is which. The motherboard manual will also show you exactly where to connect the front panel connector cables.


Your case has front panel audio and mic but doesn't cut audio from main speakers when you insert headphone jack in front panel?

The audio signal to the speakers are not cut off since the connection to the front panel and speakers are in parallel.


What computer case is best at cooling?

There isn't a computer case with the "best" airflow.A computer that intakes air at the front and distributes this at the rear is fine...Heavy Graphics = Side panel fanCPU = Side panel fan/Liquid cooling.Some are:Silverstone RV02-EThe Cooler master 'HAF' seriesAntec Lanboy Air


Where is the hard drive located in the computer tower?

The hard drive disk is well.. obviously inside the computer but it tends to be more towards the bottom of the front panel.. below the CD-ROM drives and Floppy drives. It will generally be the bottom one. If you're going to remove it make sure that you are EXTREMELY careful with it. Try to wear a grounding bracelet or use some sort of grounding method when messing around with the inside of your computer. The most common method without having to buy anything is simply having one hand on the computer case. DO NOT drop your hard drive and do not place around magnets or water. DO NOT TAKE apart as this will ruin it. The hard drive is obviously one of the most important parts of the computer and must be treated very carefully.


Where is the transfer case control module located in Chevy Blazer 98?

behind the passenger side front inside wall panel next to glove box


What should you do before disconnecting the wires leading from the front of the computer case to the motherboard if you don't have the motherboard manual handy?

d


What does a case do to a computer?

A case protects a computer when it is dropped.


How can you disable an embedded component on the motherboard?

Generally, this is a very bad idea. The only instance in which I would ever do it is to disable an integrated graphics chip and use a deticated one. I have an article from EHow below.Many computers are purchased with integrated graphics built into the motherboard. Integrated graphics are getting more powerful all the time, but a dedicated graphics card is much more powerful than graphics integrated with your motherboard, according to the Microsoft website. To get more power and performance from your computer, upgrade to a dedicated graphics card. To change to a graphics card from integrated graphics, simply install your new video card.Instructions1Turn off your system and remove all cables from the rear panel of the computer tower. Flip the switch for the power supply to the off position if your computer's power supply has a power switch. Press the power button on the disconnected computer to release any stored charge the computer still holds in its motherboard.2Remove the screws that secure the computer's side panel. There are normally two to three screws securing the side panel of a computer tower. Newer computers sometimes use thumbscrews or latches to keep the side panel in place.3Open the computer case by removing the side panel. Place the computer on its side to allow easy access to the computer's expansion slots located on the motherboard. Touch the metal casing on your computer's power supply to ground yourself and prevent static electricity from damaging your system.4Align your graphics card with the motherboard's expansion slot and press it firmly down to insert the new video card. Secure your new graphics card to the rear panel of your computer with a single computer case screw to keep it in place. Connect the graphics card to your computer's power supply if your card requires an external source of power.5Replace the side panel of the computer and tighten the screws that keep the side of the computer case secure. Attach your computer cables to the rear panel of your computer case and turn your computer's power supply switch to the on position. Double-check that you have connected your monitor cable to the newly installed video card. Press the power button on the front panel of your computer to boot your system.6Turn on your computer monitor to ensure your monitor is receiving a signal from the new graphics card. Your motherboard will automatically detect that a card is plugged into the expansion slot, and use the installed graphics card for video.7Insert the driver installation disk and follow the installation media's instructions. If necessary, restart your computer to apply the new driver settings and configuration for your graphics card.


What do you call the plastic or metal case that holds the components of a computer together?

Case


Why won't the USB ports work on the front of my computer?

The USB ports in front of the case usually require to be connected and powered. Most often the are not connected but you can connect them by opening your case and looking for certain wires. You would best be off taking it to a repair centre.


Where is the earphone jack on a computer?

It could be anywhere on the case ! On my laptop - it's on the front edge of the lower half of the case. Each computer is different - but the jack should be easy to find if you look for it. Most computers come with an electronic guide - showing where all the connectors are - check in there.


Where is the computer on a 1989 Corvette?

I think this is still the earlier L98 engine and not the more recent LT1 engine. If that is the case, the computer is above passenger knees, behind the bulky passenger side dash panel. On LT1, computer has been moved into engine compartment, above brake booster.