answersLogoWhite

0

by action of points

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

One lightning arrestor covers how much area?

Lightning arrestor or lightnng ROD? An arrestor typically covers a given electrical circuit- lightning rods cover outside area. Area will depend on the heighth of the rod above lower surfaces.


How does a lightning arrester works?

Actually when there is lightning it directly falls on lightning arr-ester and this lightning arr-ester is connected with ground wire so that it could not damaged the rest system.AnswerA lightning arrestor is a protective device used to protect high voltage power lines against lightning strikes. The upper end of the lightning arrestor is connected to a line conductor, and the lower end is connected to earth. For normal operating voltages, the lightning arrestor acts as an insulator, but when a particular voltage is reached due to a lightning strike, the device conducts, providing a path to earth.


Why the rating of lightning arrestor is less than its rated voltage eg for 400 kv system it is 360?

The MAXIMUM rated voltage is the voltage at which the electricity would arc across the insulators The usage voltage is lower than the rated voltage (usually somewhere around 80% The lightning arrestor voltage is in between. It will not pass current at the usage voltage, but will pass current when the voltage exceeds the arrestor threshhold


What is Lightning arrestor?

A device, composed of sharp points and/or knife edges, that discharges powerline overvoltages to ground. The term lightning arrestor is a misnomer, as these devices cannot protect against a direct strike to the powerline!


What does LA mean in 3 phase power systems?

LA is short form for Lightning Arrestor


How can you stop water pipes from water hammer?

Install a water hammer arrestor (air chamber)


Why lightning arrestor should be placed near transformer?

A lightning arrestor acts to reduce a voltage surge due to, for example, a lightning strike on a power line. This will protect the transformer from an over-voltage acting to break down its resistance. A lightning arrestor is connected between each line conductor and earth. Under normal voltage conditions, it acts as an insulator, but when a critical value of over-voltage is reached, it conducts -suppressing the voltage spike.


Where should I install a water hammer arrestor in my plumbing system?

Install a water hammer arrestor near the source of the problem, typically near the shut-off valve or at the highest point in the plumbing system. This will help absorb the shock waves and prevent noisy pipes.


What is thunder arrestor?

A thunder arrestor, also known as a lightning arrester, is a device used to protect electrical equipment from damage caused by lightning strikes. It works by providing a low-impedance path for the lightning to follow, directing the electrical surge safely to the ground. Thunder arrestors are commonly installed on buildings, power lines, and telecommunication towers to prevent costly equipment damage and ensure safety.


For what purpose is a gas discharge arrestor used?

A gas discharge arrestor is used to protect electrical equipment from damage caused by lightning strikes or voltage surges in power lines. It diverts excess voltage to the ground, preventing it from damaging the connected devices.


What is an arrestor?

An arrestor is an alternative term for a buffer stop.


Can you protect buildings from being struck by lightning?

Yes, install a lightning rod.