120
18 inches (45cm)
15
A cable that converts VGA to RCA has 19 pins. The VGA cable has 15 pins, 3 pins are in the center of the RCA jack, and one pin is unused. This will work to convert an older tv to work with newer cable services.
15 Characters
180 Would be 15 % so you would get 1020 Back.
A 13-15 watt compact fluorescent bulb (CFL) or a 9-11 watt LED bulb is roughly equivalent to a 60 watt incandescent bulb in terms of light output.
A 15-watt fluorescent should produce about as much light as a 75-watt incandescent.
an A15 bulb is a standard (medium) base screw-type bulb with a smaller envelope designed for appliances and some ceiling fans. They are almost always the size found in refrigerators.
So to replace a traditional 60-watt bulb, buy a 15-watt CFL: 60-watt incandescent / 4 = 15 watts. Note: Some brands of 60-watt equivalent CFLs still do not seem to give off as much light as a 60watt incandescent bulb.
If the two bulbs use the same technology the 100 w bulb is 10/6 times brighter than the 60 w. Incandescent bulbs give about 10-12 lumens per watt Halgogen gives about 15-18 lumens per watt CFL (low-energy) gives about 50 lumens per watt.
ahm...depends on the cost per watt charged by your local provider... how much is it?
fluorescents are about 5x as efficientso a 12W will give about as much light
A little bit less than a 25 watt incandescent bulb - the the table below:Bulb brightnessA 100 watt Bulb is rated at approximately 1700 lumensA 60 watt incandescent bulb is rated at approximately 800 lumensA 40 watt bulb is rated at approximately 400 lumensA 25 watt bulb is rated at approximately 180 lumensA 4 watt night light bulb is rated at approximately 20 lumens
Usually the 60-watt limit is used to prevent the lampshade overheating, so a 75-watt bulb should not be used. But if more brightness is required, try a low-energy bulb because a 15-watt one gives the same light as a 75-watt incandescent (old-style) bulb. Or a 20-watt would be even brighter.
A CFL light bulb can save about 75% of energy compared to an incandescent bulb. This is because CFLs are more efficient in converting electricity into light, while incandescent bulbs produce more heat than light, resulting in greater energy waste.
Fuses or breakers are used to protect the conductor to the load. A #14 wire conductor is rated for 15 amps. Most home circuitry is done with #14 wire. The minimum size breaker in an electrical panel is 15 amp so it looks like a 15 amp fuse or breaker can be used for a 100 watt light bulb.
It depends on the type of bulb used. The term "60 watt" is the power consumed by an incandescent bulb producing about 800 lumens of light. This would use about 1.44 Kw-hr of electricity if operated continuously for 24 hours.A compact fluorescent lamp (CFL) would require only 13 to 15 watts, about 25% as much electricity.A light-emitting diode lamp (LED) would require only 6 to 8 watts, about 13% as much as the 60-watt.