0
What else can I help you with?
What is strobe input in multiplexer?
It is the enable line. Used to enable the multiplexer to function. For low enable multiplexers, strobe is set to 0 to enable the multiplexer whereas in high enable multiplexers, it is set 1 to enable the multiplexer.
How could you plan and implement a web based enquiry system of a tourist company?
You can used PHP and Mysql
How can you implement a queue using stacks efficiently?
To implement a queue using stacks efficiently, you can use two stacks. One stack is used for enqueueing elements, and the other stack is used for dequeueing elements. When dequeueing, if the dequeue stack is empty, you can transfer elements from the enqueue stack to the dequeue stack to maintain the order of elements. This approach allows for efficient implementation of a queue using stacks.
What is micro operation?
Micro-operations are detailed low-level instructions used in some designs of computer central processing units. They mainly implement complex machine instructions.
How can I implement a timer in Fortran to measure the execution time of my program?
To implement a timer in Fortran to measure the execution time of your program, you can use the SYSTEMCLOCK function. This function returns the current processor time, which can be used to calculate the elapsed time. You can call SYSTEMCLOCK before and after the code segment you want to measure, and then calculate the difference to determine the execution time.
What is strobe input in multiplexer?
It is the enable line. Used to enable the multiplexer to function. For low enable multiplexers, strobe is set to 0 to enable the multiplexer whereas in high enable multiplexers, it is set 1 to enable the multiplexer.
Why put a multiplexer at the end of a circuit?
Multiplexers are used to transfer many signals over one line, and several control lines. You put it at the end of a circuit if you plan to send the output from that circuit to another circuit, so you use the least lines possible.
What are the everyday applications of decoders encoders and multiplexers demultiplexers?
Multiplexer is a device that will select one input and put it through. De- multiplexers will take one signal and broadcast to many devices. Encoder will take a signal and code it with information specific to an application. Decoder will extract the encoded signal to restore in its original form
Can multiplexers are used in stop watch?
yes you can
Which can be used as a data selector?
multiplexer.
Function of demultiplexer?
A demultiplexer is a circuit. It has one input but more than one output. A demultiplexer gives binary information from one end to another. It is used to connect a single source to many destinations.
What kind of switches are commonly used in Pam multiplexers?
fets are used due to their high speeds
What of the circuit can be used as parallel to serial converter?
multiplexer can be used as parallel to serial converter.
How does a multiplexer operate?
Multiplexer is a generic term. Multiplexer can be anything that takes signals from several devices and sends the info through one channel. Usually demultiplexor is used on the other end to select the right device to send the info to. Does this help. Just Google it for more info. Good luck.
What were frequency division multiplexers used for?
Their primary use was to connect multiple, slow-speed data terminals over voice channels
What is difference between encoder and multiplexer in digital electronics?
An encoder refers to a device that is used to change a signal or data into a code. Whereas a Multiplexer or mux is a device which performs multiplexing or it takes information from more than one channels and outputs into a single channel. Thus a multiplexer is basically a kind of encoder where its function is to combine multiple inputs into one output.
How many lines of code were used to implement MS-Dos?
Around 4,000 lines assembler code.
