Technically, a router can be flashed and custom programmed to run faster, and have higher wattage for WAN. I would not recommend doing this, as it may burn up your router and turn it into garbage if not done correctly. I have done this myself, and use it as a paperweight now. So the answer, YES it is possible but not recommended.
Yes, it's possible. Connect the wire coming from the switch in the internet port in the router.
No, You cannot run two BGP process on a Single Router. Yes, it is possible if you use different VRFs
Yes, it is possible by downloading the firmware’s recent version through dlink-router-local.net support website.
A router can be used to connect a LAN to the internet. A router works on the basis of an IP address. Every router has built-in operating system known as IOS. A router works on the network layer of the OS model and it routes the data towards the optimal path. Router uses the header information of the packets and forwarding table to define the best shortest possible path of the data.
the router is assigned an ip address.
Overclocking an XBOX 360 is illegal and pontentially dangerous.
Possibly, possibly not. It is possible that the router will burn out at some point from use, but it is also possible that the router will not ever burn out (just lose its ability to do other things).
The correct configuration management process to overclock your processor is going into the BIOS settings, and increasing the power of the motherboard. This is the safest way as well to overclock.
It is possible with homebrew software.
Yes, it's possible. Connect the wire coming from the switch in the internet port in the router.
The router discards the packet. The router forwards the packet via the default route
In general, no it is not possible. Some routers run a version of Linix. If that is the case with your router, it might be possible.
Between the modem and the computers.
It would be possible to obtain a Cisco router cable from various different stores and outlet stores that sell cables and other equipment for internet connections such as the Cisco router cable in particular.
no
Yes it is possible to use a Netgear wifi router on a smartphone. Smartphones have a wifi receiver that it can be used for wifi repeating or wifi giving.
Does not seem possible the router must be set to turnoff if the PS3 is not being used and not set to always on