It can Be measured with a meters or the stopwatch or amything.
The CPU cycle time is the time between start up and shutdown
Access Time measured in MHz
•Amplitude-Height (loudness) of the wave-Measured in decibels (dB)•Frequency:-Number of waves that pass in a second-Measured in Hertz (cycles/second)-Wavelength, the length of the wave from crest to crest, is related to frequency•Phase:-Refers to the point in each wave cycle at which the wave begins (measured in degrees)-(For example, changing a wave's cycle from crest to trough corresponds to a 180 degree phase shift).
CPU Speed is meshed in Gigahertz. For example: Abbreviation for gigahertz. One GHz represents 1 billion cycles per second. The speed of microprocessors, called the clock speed, often is measured in gigahertz. For example, a microprocessor that runs at 200 GHz executes 200 billion cycles per second.
Fetch Decode Execute. This is the cycle that processors will follow. Fetch the Instruction, Decode it into machine code, Execute the commands
NS
Lead time is typically used to specify how long the delivery of a piece of equipment will take from purchase order to delivery. Cycle time is the amount of time measured in seconds or minutes a piece of equipment operates at. This is measured from the start of one cycle to the start of the next cycle.
machine
The combination of I-Time and E-Time called is called the 'Machine Cycle'
the clock oscillator and machine cycle state machine, it may take multiple clock cycles per machine cycle.
gravity
an instruction cycle may consist of a number of machine cycles.
How long is a wash cycle? A normal wash cycle usually takes between 50 minutes to an hour to complete. However, this time could be faster or slower depending on load size and the cycles or options you choose.
Yes, a washing machine transitions from one cycle to another. There is a water cycle that transitions to a wash cycle, then it transitions to a rinse cycle, a spin cycle and so on.
My GE washing machine does not wring my clothes dry enough what do i need to do? The spin cycle is not working well. You can try running the spin cycle a second time. Also, make sure that you have not overfilled the machine. In my experience, this is the main reason for replacing an older machine.
To ensure that the door is not opened before the drain cycle has finished.
Timing Diagram is a graphical representation. It represents the execution time taken by each instruction in a graphical format. The execution time is represented in T-states.Instruction Cycle:The time required to execute an instruction is called instruction cycle.Machine Cycle:The time required to access the memory or input/output devices is called machine cycle.T-State:The machine cycle and instruction cycle takes multiple clock periods.A portion of an operation carried out in one system clock period is called as T-state.MACHINE CYCLES OF 8085:The 8085 microprocessor has 5 (seven) basic machine cycles. They areOpcode fetch cycle (4T)Memory read cycle (3 T)Memory write cycle (3 T)I/O read cycle (3 T)I/O write cycle (3 T)Each instruction of the 8085 processor consists of one to five machine cycles, i.e., when the 8085 processor executes an instruction, it will execute some of the machine cycles in a specific order.The processor takes a definite time to execute the machine cycles. The time taken by the processor to execute a machine cycle is expressed in T-states.One T-state is equal to the time period of the internal clock signal of the processor.The T-state starts at the falling edge of a clock.