COM2 typically uses IRQ 3. The Interrupt Request (IRQ) is a signal used by hardware devices to get the attention of the CPU. In the case of COM2, which is a communication port, it uses IRQ 3 to communicate with the CPU for data transmission and reception.
COM1-IRQ 4, memory addresses 03F8-03FF COM2-IRQ 3, memory addresses 02F8-02FF COM3-IRQ 4, memory addresses 03E8-03EF COM4-IRQ 3, memory addresses 02E8-02EF pg. 396
LTP1 should use IRQ7.
0
IRQ Ports 2 & 9 -Taylor
Yes on a modern computer you will need a USB to 9 pin RS232 converter or previously use the LPT parallel port.
IRQ 3
COM1-IRQ 4, memory addresses 03F8-03FF COM2-IRQ 3, memory addresses 02F8-02FF COM3-IRQ 4, memory addresses 03E8-03EF COM4-IRQ 3, memory addresses 02E8-02EF pg. 396
The default IRQ for COM2 is typically 3, while for COM4, it is usually 5. These IRQ settings allow the operating system to manage hardware interrupts for the respective serial ports. However, these values can sometimes vary based on the system configuration and settings in the BIOS. Always check your specific system documentation for accurate IRQ assignments.
COM1 is assigned 3F8h and uses IRQ Channel 4, COM2 is assigned 2F8h and uses IRQ Channel 3, COM3 is assigned 3E8h and uses IRQ Channel 4
IRQ 3 is for COM2 and COM4 (serial ports). See related link.
LTP1 should use IRQ7.
IRQ 0 - System timer. IRQ 1 - Keyboard. IRQ 2 - Cascaded signals from IRQs 8-15. IRQ 3 - COM2 (Default) and COM4 (User) serial ports IRQ 4 - COM1 (Default) and COM3 (User) serial ports IRQ 5 - LPT2 Parallel Port 2 or sound card IRQ 6 - Floppy disk controller IRQ 7 - LPT1 Parallel Port 1 or sound card (8-bit Sound Blaster and compatibles) IRQ 8 - Real time clock IRQ 9 - Free / Open interrupt / Available / SCSI. Any devices configured to use IRQ 2 will actually be using IRQ 9. IRQ 10 - Free IRQ 11 - Free IRQ 12 - PS/2 connector Mouse. IRQ 13 - ISA / Math Co-Processor IRQ 14 - Primary IDE. If no Primary IDE this can be changed IRQ 15 - Secondary IDE These are just a set of standard IRQs. For much more detail check our Ralf Brown's list located at http://www.cs.cmu.edu/~ralf/files.html
IRQ 1 is used exclusively for the keyboard controller.
None. Its the graphics card that uses an IRQ. The monitor is just a peripheral.
Hi, correct combination of default combination of COM ports and IRQ is given below: 1. com1 and com3 - IRQ4 2. com2 and com4 - IRQ3 below link can easily explain the answer in details. You can even see this in device manager properties. i.e. mycomputer > properties > device manager> IDE/ATA controller > resources > irq=20 link : http://www.webopedia.com/quick_ref/IRQnumbers.asp
0
5